Publicidad
F 215
INSTRUCTION MANUAL
Para Español ver página 22
Want to watch
a video that
shows how
easy this DIY
project will be?
Watch it now at:
SANUS.com/2773
WE'RE HERE TO HELP
Recommended placement
Check it out at:
SANUS.com/1171
Get it right the
first time.
HeightFinder™
shows you
where to drill.
Call us at:
888-333-9952
BONUS!
+
Two 10"
4K HDMI
Cable
Cable
Tunnels
Our US-based
install experts
are standing
by to help.
Or, chat at:
SANUS.com/chatSV
Publicidad
Tabla de contenido
Manuales relacionados para SANUS VuePoint F215
Resumen de contenidos para SANUS VuePoint F215
- Página 1 BONUS! F 215 INSTRUCTION MANUAL Two 10" 4K HDMI Cable Cable Para Español ver página 22 Tunnels WE’RE HERE TO HELP Want to watch Get it right the Our US-based Recommended placement a video that first time. install experts shows how HeightFinder™...
- Página 2 IMPORTANT SAFETY INSTRUCTIONS – SAVE THESE INSTRUCTIONS – PLEASE READ ENTIRE MANUAL PRIOR TO USE Before getting started, let’s make sure this mount is perfect for you! Does your TV No — Perfect! (including accessories) 50 lbs. Yes — This mount is NOT compatible. Visit MountFinder.sanus.com or call weigh more than (22.6 kg) 50 lbs.
- Página 3 Dimensions TV INTERFACE 3.94in 15.75in 100mm 400mm 7.87in 200mm 11.81in 300mm .34in 8.7mm WALL PLATE TOP VIEW - EXTENDED SIDE VIEW - EXTENDED 2.91in 4.02in 5deg 74mm 102mm 15deg .99in .33in 25.2mm 8.4mm 9.06in 45deg 45deg 230mm 8.27in 210mm 15.0in 381mm ROLL CONTROL TOP VIEW - RETRACTED...
- Página 4 Supplied Parts and Hardware WARNING: This product contains small items that could be a choking hazard if swallowed. Before starting assembly, verify all parts are included and undamaged. If any parts are missing or damaged, do not return the damaged item to your dealer;...
- Página 5 STEP 2 Parts and Hardware STEP 2B: Concrete Installation Kit CMK1 [NOT INCLUDED] Contact Customer Service at 1-888-333-9952 to have these W E L C O M E ! additional pieces shipped directly to you. C H O O T H A N S IN G K S F O S A N U...
- Página 6 STEP 1 Attach Faceplate to TV 1.1 Measure Your TV Hole Pattern 1.2 Assemble Your Faceplate Based on your TV hole pattern measurements Measure the width and height of your TV ), determine your Faceplate hole pattern in mm. configuration: A, B, C, D or E. Record your measurements: For TV Hole Pattern Measurements...
- Página 7 For TV Hole Pattern For TV Hole Pattern For TV Hole Pattern Measurements Measurements Measurements (Dimensions in mm) (Dimensions in mm) (Dimensions in mm) 400 x 300 200 x 300 300 x 200 200 x 400 400 x 200 [15¾ in.] [15 ¾...
- Página 8 1.3 Select TV Screw Diameter 1.4 Select TV Screw Length Standard configurations are shown. For special Test the four TV screw diameters (M4, For flat-back TVs, Spacers supplied for: applications, or if you M6, and M8) in the threaded inserts on are uncertain about your no spacers the back of your TV to determine which...
- Página 9 1.5 Attach TV Bracket Position your TV bracket configuration (A, B, C, D or E) onto your TV, making sure the bracket is both centered and level over your TV hole pattern. NOTE: The hanging tab on faceplate must be oriented toward the top of the TV. Secure the TV bracket using your selection: screw/washer or screw/washer/spacer.
-
Página 10: Wood Stud Installation
STEP 2A Attach Wall Plate to Wall Wood Stud Installation CAUTION: Avoid potential personal injury or property damage! ● Drywall covering the wall must not exceed 5/8 in. (16 mm) ● Minimum wood stud size: nominal 2 x 4 in. (51 x 102 mm) actual 1 ½ x 3 ½ in. (38 x 89 mm) Locate your stud. - Página 11 Drill pilot holes using a 7/32 in. (5.5 mm) diameter drill bit. Remove template IMPORTANT: Be sure to drill into the center of the stud. IMPORTANT: Pilot holes must be drilled to a depth of 2 ¾ in. (70 mm). Install full motion arm using two lag bolts .
- Página 12 STEP 2B Attach Wall Plate to Wall Solid Concrete / Concrete Block Installation CAUTION: Avoid potential personal injury or property damage! Concrete Installation Kit CMK1 is not included (see page 5) Contact Customer Service ● Mount wall plate assembly directly onto concrete surface (no wall covering) at 1-888-333-9952 to have the additional ●...
- Página 13 Remove the template and insert two anchors (Fischer UX 10 x 60R - included in the Concrete Installation Kit CMK1*). CAUTION: Be sure the anchors are seated flush with the concrete surface. Install full motion arm using two lag bolts .
- Página 14 STEP 3 Hang TV onto Wall Plate HEAVY! You may need assistance with this step. Install the nut cap on wall plate assembly Fold first section of the arm of full motion arm against the wall to provide stability.
- Página 15 Hang the TV onto the arm of full motion arm by first hooking the hanging tab , then resting the TV into place. Lock the TV to the full motion arm with locking screw and washer IMPORTANT: This locking screw must be installed to secure the TV onto the full motion arm...
- Página 16 Manage Cables Fully extend the arms before routing cables. Route the cables through the channels on the top and bottom of the arm for a cleaner look.
- Página 17 Manage Cables - Cable Tunnel Space clips evenly along the length of the tunnel(s) NOTES: with a clip near each end. To combine tunnels, use the long clip to connect where they meet. ● This product is NOT recommended for brick, plaster, or Press firmly until clips snap in place.
- Página 18 Carefully lift tunnel assembly and position it at the desired location making sure it is level. Peel the tunnels away from Press firmly for 10 the clips seconds at each clip Arrange cables on either location along the side of the clips. Reattach length of the assembly tunnels to clips...
- Página 19 TV Adjustments TILT ADJUSTMENT LEVEL ADJUSTMENT To adjust the leveling of your TV, loosen the locking screw , level Your TV should adjust easily when moved, then stay in place. your TV, then tighten locking screw If your TV is too loose or too tight, adjust the tilt tension knob by hand. IMPORTANT: This locking screw must be installed to secure NOTE: Once your TV is in place, tighten the tilt tension knob to...
- Página 20 REMOVING THE TV HEAVY! You may need assistance with this step. Disconnect the cables from your TV. Remove locking screw Carefully lift your TV up and off of wall plate assembly...
- Página 22 ESPAÑOL INSTRUCCIONES DE SEGURIDAD IMPORTANTES. CONSÉRVELAS. LEA TODO EL MANUAL ANTES DE UTILIZAR ESTE PRODUCTO. Antes de comenzar, verifiquemos que este soporte sea el ideal para sus necesidades. ¿Su televisor pesa No — ¡Perfecto! más de 22.6 kg 22.6 kg , incluidos (50 libras) Sí...
- Página 23 ESPAÑOL Dimensiones Ver página 3 Piezas y accesorios suministrados Ver página 4 ADVERTENCIA: Este producto contiene piezas pequeñas que, si fuesen tragadas, podrían producir asfixia. Antes de iniciar el ensamblaje, compruebe que todas las piezas estén incluidas y en buenas condiciones. Si faltan piezas o alguna está dañada, no devuelva el artículo al distribuidor;...
-
Página 24: Montantes De Madera
ESPAÑOL 1,5 Fije la placa de sujeción Coloque su configuración de soporte de televisor (A, B, C, D o E) sobre el patrón de orificios de su televisor, asegurándose de que el soporte esté centrado sobre el patrón de orificios del televisor y nivelado. NOTA: La lengüeta colgante del soporte del televisor debe estar orientada hacia la parte superior del televisor. -
Página 25: Paso 3 Colgar El Televisor En La Placa Mural
Ver página 12 ESPAÑOL PASO 2B Fijar la placa mural Hormigón sólido o bloques de cemento PRECAUCIÓN: Evite lesiones y daños materiales. El Kit de instalación en hormigón CMK1 no está incluido ● (Ver página 5) Instale el módulo de la placa mural directamente sobre la superficie de hormigón Comuníquese con el servicio de atención ●... -
Página 26: Organización De Cables
ESPAÑOL Organización de cables Ver página 16 Los cables pueden pasarse por los canales para cables que se encuentran en la parte superior del brazo del módulo de la placa mural para un aspecto más prolijo. Pase los cables alrededor del poste del brazo y a través del área abierta del brazo, tal como se muestra en la imagen, para evitar aplastar los cables al plegar el brazo. -
Página 27: Ajustes Del Televisor
ESPAÑOL Separe los clips de forma pareja a lo largo de la longitud del túnel poniendo un clip en cada extremo. Para combinar túneles, use el clip largo para conectar los puntos en los que se encuentran. Presione firmemente hasta que los clips encajen en su lugar. Retire la parte posterior de las almohadillas adhesivas de los clips. - Página 28 ©2018 Milestone AV Technologies. All rights reserved. SANUS VuePoint, HeightFinder and the VuePoint logo are trademarks of Milestone. All other brand names or marks are used for identification purposes and are trademarks of their respective owners.