Installation Of The Led Controller - Blumfeldt Climax Ambient Manual Del Usuario

EN
62
Direct color selection
This key takes you directly to the static color selection. When you
6
press a specific color key, the LED lights up in the corresponding
color. Direct color selection is included when using the COLOR+
and COLOR- keys.
Brightness adjustment
Brightness adjustment of static colors. Press the BRIGHT+ key
7/8
to increase the brightness and the BRIGHT- key to decrease the
brightness. The device automatically switches to static color mode
when this key is pressed in dynamic mode.
Demo mode
When you press this key, you enter the demo mode. In demo mode,
11
17 dynamic modes are played in continuous loop and each mode is
repeated three times.

INSTALLATION OF THE LED CONTROLLER

Power supply
A power supply between DC 5 V to 24 V can be used for this device. The inner
pole (or red wire) of the DC socket is positive and the sleeve (or black wire) is
negative. Also, make sure that the line voltage matches the LED voltage.
LED Output
This unit supports conventional LED products with anode connection.
The [ ] mark indicates the common connection node.
The peak output current is 4 amps and the maximum continuous current is 2
amps per channel. Please reduce the load when the main unit overheats.
Note: Do not short circuit or overload the LED outputs. This may cause
permanent damage!