Blumfeldt Climax Ambient Manual Del Usuario página 64

EN
64
Free remote control pairing mode
In some special cases, the main unit needs to be paired with any remote
controls.
1. Turn off the main unit, unplug it and wait for 5 seconds. Then plug the
connector back in and start the main unit.
2. Press the [ON/STANDBY] and [MODE+] buttons simultaneously within 5
seconds after power on.
After this procedure, the main unit will recognize all existing remote controls.
To pair the main unit with a specific remote control, repeat the „Pairing a new
remote control" procedure.
Switching the order of output colors
The default order of the controller output colors is green-red-blue. If the color
buttons do not match the LED color, adjust the output color order as follows:
1. Turn off the main unit, unplug it and wait for 5 seconds. Then plug the
connector back in and start the main unit.
2. Press the [red] and [blue] buttons simultaneously within 5 seconds after
power on.
With this operation, the output sequence switches between 6 possible
combinations. The 6 possible combinations are stored and activated after the
next power off and on.