Error Display; Replacing The Batteries - De Dietrich FM161 Instrucciones De Utilizacion

6. Applying an exception to one or more circuits
6 Applying an exception to one or more circuits
The MODE key is used to select an operating mode for the circuit
(and only that circuit) controlled by the remote control.
It is nonetheless possible to apply an exception to each circuit by
selecting the operating mode from the Diematic 3 control panel. If one
of the circuits is in an override mode different from the others, the
SHOW REM. CTRL message is displayed to identify the override.

7 Error display

1 2
0 2 4

8 Replacing the batteries

When the batteries have to be replaced, the battery symbol
flashes in the display (
Use commercially available alkaline batteries type
LR 6 AA 1.5 V.
Do not use rechargeable batteries!
The display on the remote control shows "init" for a few seconds
during which the remote control can be synchronized.
Settings previously made remain in the memory.
In order to keep the clock setting, the boiler must remain
switched on during this operation.
13
3 4 5 6
6 8 10 12 14 16 18 20
C
).
Then press the AUTO key on the Diematic 3 control panel for 5
seconds.
The message is deleted.
Apply the desired exception to each circuit.
For example: When going on holiday and wishing to set the
antifreeze mode for each heating and DHW circuit in the house.
If there is an operating fault, the remote control displays the message
"Error".
The display on the Diematic 3 boiler control panel then indicates the
cause of the fault.
FM161 - FM162
#
#
#
17/03/08 - 300009548-001-B