Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION DIAGRAM
1.
Screw
2. Pegboard
3. Spacer
4. Wall
5. Anchor
HANGING PEGBOARD
NOTE: Follow this order for best
results. Do not fully tighten screws
until all 21 are in place.
1.
Fasten 3 top screws (A).
•
3rd row from top, 33rd, 48th
column from left, and 34th column
from right.
2. Fasten 3 center screws (B).
•
24th row from top, 33rd, 48th
column from left, and 34th column
from right.
3. Fasten 4 inner side screws (C).
•
3rd row from top, 17th column from
left and 18th column from right.
•
24th row from top, 17th column from left
and 18th column from right.
4. Fasten 4 outer side screws (D).
• 3rd row from the top, 2nd column from the left
and 2nd column from the right.
• 24th row from the top, 2nd column from the left
and 2nd column from the right.
5. Fasten 7 bottom screws (E).
• 3rd row from the bottom, 2nd column from the left
and 2nd column from the right.
• 3rd row from the bottom, 17th column from the left
and 18th column from the right.
• 3rd row from the bottom, 33rd, 48th column from
the left, and 34th column from right.
PAGE 2 OF 6
Wall
Pegboard
Screw
Anchor
Spacer
(See Figure 1)
INSTALLATION
PREPARATION
1.
With someone holding the pegboard in place, mark
all holes on wall according to Figure 1 below where
screws will be inserted for hanging. (See Figure 1)
2. Pre-drill holes in wall if using anchors.
NOTE: Use a 3/16" drill bit.
3. Insert anchors into holes in wall.
4. Following Figure 1 below, glue spacers to back of all
pegboard holes through which screws will be inserted.
Be careful to glue spacers over the same pegboard
holes used to mark wall in step 1 or spacers and
holes in wall will not line up correctly. (See Figure 1)
D
C
1-800-295-5510
uline.com
A
B
E
Figure 1
C
D
0421 IH-5796
Publicidad
