Maintenance And Storage - Hoberg GT100 Traducción Del Manual De Instrucciones Original

Technique – Trimming Along A Kerbstone
• Align the trimmer unit (11) parallel with the ground. The angle of the trimmer unit to
the ground should not exceed 20° (Picture F).
• Hold the edge guide (8) against the kerbstone, wall or similar structure.
Slide the device forwards along the kerbstone or similar structure (Picture I).
•

Maintenance and Storage

PLEASE NOTE!
■
All moving parts are maintenance-free.
■
Do not use any degreasing agents.
■
Do not use any caustic or abrasive cleaning agents! These may damage the
surface.
General Inspection
• Regularly inspect all screws to make sure they fi t securely as over time they can
become loose due to vibrations.
• Check the device and all accessories for damage on a regular basis. Do not use it if
the device or the accessories are damaged.
• Regularly inspect the cutting elements to check their condition and secure fi t.
Cleaning
Keep the device clean at all times. Dust and dirt will cause the parts to wear more
quickly and the lifespan of the device may be reduced.
• Clean the device with a soft brush or a damp cloth.
• Clean the ventilation slots with a brush, a vacuum cleaner or clean, dry compressed
air, if available.
Lubrication
• It is not necessary to lubricate any moving parts of the device.
Maintenance
• Damaged or worn cutting elements must be replaced. Spare cable ties or trimmer
threads are available from www.hoberg-shop.de (spare part number for cable ties
44313180100 and trimmer threads 44313180200).
Storage
• Store the device and accessories in a dry, clean place which is protected from the
effects of weather and temperature and is out of the reach of children and animals.
EN
23