General Information On Recording - Philips AQ 6345 Manual Del Usuario

00 02-02-2000 11:02
TE PLAYBACK
LAYBACK
assette door and insert a tape (see fig. 2).
oor lightly to shut.
yback, press 1.
sound with VOLUME.
al mono sound listening, insert 3.5mm
s (preferably type ≥16 ohms) into the p socket.
n speaker will then be disconnected.
d, press 5 or 6.
tape counter display to find the point in the tape
o listen to. Press 9 to stop fast winding at the
oint.
lso allows you to fast cue or review during
Using the tape counter to monitor passages, hold
5 or 6 and release the key at the passage you
playback continues from this point.
e tape counter display to 000, press the
RESET switch.
so adjust TAPE SPEED to find or listen to
uring playback. Set TAPE SPEED to:
speed playback;
al speed playback;
speed playback.
set TAPE SPEED to 0 for normal playback!
All manuals and user guides at all-guides.com
Pagina 6
8. For brief interruptions, adjust PAUSE ;. To deactivate
pause, slide the switch back again.
9. To stop playback, press 9 and the set is switched off.
• At the end of a tape, the 1 key is automatically released
and the set switched off, unless PAUSE ; has been
activated.

GENERAL INFORMATION ON RECORDING

• This set is not suited for recording on CHROME (IEC II) or
METAL (IEC IV) type cassettes. You should only use
NORMAL type cassettes (IEC type I) on which the tabs have
not been broken.
• Altering the VOLUME and TAPE SPEED controls will not
affect the recording in progress with the exception of when
VOICE ACT is in use and VOLUME is adjusted.
• At the very beginning and end of the tape, no recording will
take place during the 7 seconds when the leader tape
passes the recorder heads.
• Recording is permissible insofar as copyright or other rights
of third parties are not infringed.
RECORDING