Truma Panel EM LED Instrucciones De Uso página 7

Connection
1/2 1/2
0 <11.5V <11.5V
II II
Made in Germany Made in Germany
2 pol. 2 pol. 5 pol. 5 pol.
2
1 2
Waste water tank
Fresh water tank
Install the cables to the tanks and power supply.
Connect the sensors to the panel and the power supply. The
plug connectors can only be inserted to the correct connection
when they are in the right position.
Ensure that all the catches lock into place.
Installation of the filling level sensors
Waste water tank
– Establish the height of the
tank (external dimensions).
– Establish and mark the posi-
tion of the boreholes for the
sensors.
– Drill 2 holes with a diameter
of 9.5 – 10 mm into the
waste water tank.
– Smooth down the edges of
the boreholes.
– Coat the screws with seal-
ing compound or an elastic
adhesive.
– Assemble the measuring
sensors (1 wire of the 2-wire
line per measuring sensor).
– Tighten the screws by hand.
– Place each measuring sen-
sor into a borehole and
tighten with a screwdriver.
The edge of the rubber
seal is pressed against
the tank wall. The rubber
bulges inside thereby sealing
the borehole.
7 pol. 7 pol.
5 7
EM 16 IU
EM 30 IU
min. 50 mm min. 50 mm
Fresh water tank
The supplied sensor
is designed for tank
heights of 150 mm to
380 mm external dimensions
and for vertical installation.
– Establish the height of the
tank (external dimensions).
– Drill the borehole with a
diameter of 38 ± 0.5 mm
at the highest point close
to the middle of the tank
and the cleaning opening.
– If necessary, shorten the
measuring rods (see short-
ening table).
– Insert the sensor into the
cleaning opening and
screw tight – observe the
correct position of the
sealing ring.
– Tighten the nuts by hand.
Shortening table
Tank height
Measuring rod length [mm]
External
dimensions
ws
[mm]
380
370 22
360 22
350 22
340 22
330 22
320 22
310 22
300 22
290 22
280 22
270 22
260 22
250 22
240 22
230 22
220 22
210 22
200 22
190 22
180 22
170 22
160 22
150 22
The table applies for symmetrically shaped tanks.
The volume of non-symmetrical tanks needs to be
determined.
gn
ge
br
gr
ws
ws
br
1/1
gn
ge, gr
3/4
1/2
1/4
br gn ge, gr
Original length
81 170 260
78 165 253
76 160 245
73 155 238
71 150 230
68 145 223
66 140 215
63 135 208
61 130 200
58 125 193
56 120 185
53 115 178
51 110 170
48 105 163
46 100 155
45 95 148
44 90 140
43 85 133
41 80 125
39 75 118
38 70 110
36 65 103
35 60 95
7