Troubleshooting - Craftsman 315.SS630 Manual Del Operador

pROBLEM
Motor does not run.
Motor overheats.
Motor has a low hum but does not
spray.
Motor seems to be running properly
but doesn't spray.
Sprayed material is spitting, globbing
up or unable to get a preferred spray
pattern with an even amount of paint
or stain
Paint/stain spray overspray is exces-
sive.
Paint/stain runs or sags on the work
surface.
Paint/stain is leaking behind the
spray tip.
* Although unlikely, a worn piston is possible. A replacement piston can be purchased by calling customer service at
1-800-932-3188. Follow the instructions in Cleaning the Sprayer for Storage to access the piston for replacement.
All manuals and user guides at all-guides.com

TROUBLEShOOTinG

CaUSE
Battery is not charged.
Piston has seized up.
Continuous spray operation.
Piston has seized up.
Suction tube and filter are loose or
damaged.
Atomizer valve is clogged or worn
out.
Material being sprayed is too thick.
Plugged spray tip or intake filter;
worn piston.
Paint container volume is getting low.
Material being sprayed is too thick.
Suction tube is loose.
Atomizer valve is clogged or worn
out.
Worn spray tip or piston.
Spray tip is too far from the surface
being sprayed.
Proper paint methods not being
observed.
Spray tip is loose.
Atomizer valve is worn or not posi-
tioned properly.
11 - English
pOSSiBLE SOLUTiOn
Charge battery.
Thoroughly clean the sprayer using long-
term storage cleaning instructions in the
Maintenance section of this manual.
Release trigger at the end of each pass
to allow the motor to cool.
Thoroughly clean the sprayer using long-
term storage cleaning instructions in
the Maintenance section of this manual.
Reinstall or replace suction tube and
filter as needed.
Clean or replace atomizer valve.
Follow material manufacturer's direc-
tions and thin material as needed.
Thoroughly clean the sprayer and, if
necessary, replace piston*, using stor-
age cleaning instructions in the Mainte-
nance section of this manual.
Refill paint container.
Follow material manufacturer's direc-
tions to thin material as needed.
Reinstall suction tube securely.
Clean or replace atomizer valve.
Clean or replace spray tip or piston*.
Hold sprayer closer to the surface being
sprayed.
Refer to Operating the Sprayer earlier
in this manual.
Tighten spray tip.
Replace or reposition atomizer valve as
needed.