Operating The Device - Gude MBSD 116 Traducción Del Manual De Instrucciones Original

ENGLISH
24
WARNING
Using any other accessory equipment may represent
a risk of a serious injury for you.
Watch out for the feeder cable.
Do not pull the cable. Do not use it to pull the plug
out. Keep the cable out of reach of thermal sources,
oil and sharp edges.
Have your machine repaired by an expert only!
This machine meets the applicable safety provisions.
Any repairs may only be executed by an expert, using
original spare parts; otherwise, the user could face a
risk of injury.
Children and persons not familiarised with the ma-
chine and persons with limited physical, sensory and
mental skills must not use the machine.
Additional safety instructions Metal
Band Saw
Use the right saw band at all times.
The device must be switched off before inserting ma-
terial to be cut in the vice or before removing material
to be cut from the vice.
Keep your hands and fingers in a safe distance from
the running saw band at all times.
The saw band must not be braked by hand.
Safety equipment and guards, etc. must not be
removed.
Never remove the cuts by hand. Use a brush at all
times.
Never leave the device when in operation.
Putting into operation for your safety
Before carrying out any work on the machine,
disconnect the plug from the socket.
Bei unbeabsichtigtem Betätigen des Ein-/Ausschalters
besteht Verletzungsgefahr.
Assembly
Pull out the ratchet (pic. 1)for uncovering.
Length stop:
Screw the guide rail to the thread and fixate the
length stop by the screw (pic.12)
Before putting the device into operation
The working surface and area must be sufficiently lit
at all times.
Put the device on a flat, horizontal surface and check
the device if stable. Do not place the device on wall.
There must be no person in the dangerous area.
The minimum safety distance of 10m must be
respected.
Saw band
Unplug the device before any adjustment and
servicing!
Saw band stretching:
Stretch the saw band using the stretching bolt (pic.
15). The saw band is stretched correctly when it can
be pressed by 2-3 mm.
Guide adjustment:
The saw band guide must be adjusted as, otherwise,
it could get flipped over, which would result in an
unclean cut.Loosen the bolt (pic. 15/1) and adjust the
guide depending on the width of the material to be
processed.
Changing the saw band:
Loosen the saw band. Loosen the bolt and remove
the cover. Now fit in a new saw band on the rollers
and place it between the guide bearing and the band
guide. Then, stretch the saw band again and close the
covers safely and firmly.

Operating the device

Angle adjustment:
Adjust the angle to the material to be processed at all
times. To shift the entire work block, loosen the bolt
(pic. 13/1). Using both stops, precise adjustment of 0°
+45 is possible (pic. 13/2a).
Cutting speed:
The cutting speed always depends on the material
being cut. Speed can be changed by turning the knob
(pic. 16).
Maintenance
Before carrying out any work on the machine,
disconnect the plug from the socket.
The machine must not be used under any circum-
stances if the machine or the safety devices are
damaged.
If the device is defective, the repair has to be made
exclusively by the customer service.Use only original
accessories and original spare parts.
Only a regularly maintained and treated appliance
can serve as a satisfactory aid. Insufficient mainte-
nance and care can lead to unforeseen accidents and
injuries.