universalblue UCSB90201-21 Manual Del Usuario página 27

 The heater should be hung on the wall and make the
wind outlet down or be placed on flat appliance. You
must not place it precipitantly or tipsily.
 Please do not use the heater in the place where full
of combustible or explosive gas. Don't cover the
wind outlet.
If the power supply cable is damaged, it must be

replaced by the manufacturer or our service to avoid
danger.
 The heater must not be located immediately below
an electrical socket. The electrical socket must be
equipped with earth wire, its capacity should be
250V~10A or exceed 250V~10A. The socket and
the power plug should be in good connecting
condition.
 If nobody is in using or you are repairing the heater,
please pull off the plug.
 Please don't touch the heater by the wet hand or
other conductor.
 If motor is not working properly, please stop it
immediately.
 During using the heater, please do not open the door
or window continually otherwise it will influence the
heating effect.
 If want to shut off the heater, press the on/off
switch to off, then the heater will keep the fan
working 30 seconds until it blowing out cool wind,
then the heater will stop working, and you may pull
off the plug.
 Please remove the baffle before using the remote
control.
27