universalblue UCSB90201-21 Manual Del Usuario página 33

Pressing the "MODE" button second times on remote control,
the unit will blow the hot air and the
Pressing the "MODE" button Three times on remote
control,the unit will blow the cold air
PS: For smart operate,customer only press the one start button near
about master button,the heater will working with hot air and Swing
function.
24H Timer function
Press " " button ,set the timer up to 24 hours,keep press "
button to increase the hours from 00--24(00=close,01=1hour,02=2
hours...24=24 hours ect.) and the "
PS: set as "00" means no set timer ,the "
Thermostat instructions
To adjust temperature, press the "-" and "+"" to set the
desired temperature and the temperature set from 10℃ to
49℃
When the air temperature drops 2 degree below the set
temperature,the heater will start heating with "I/W"(1000W).
When the air temperature drops 4 degree below the set
temperature ,the heater will start heating with "II/H"(2000W).
When the air temperature high 1 degree or ≤ the set
temperature,the heater will blow the cold air .
Window open function
Press "
working as smart saving energy models.(In this function,the
" button, the "
" light is on.
" light is off.
" light is on.The appliance is
will light on.
"
33