General; Safety Notes; Intended Use; Notes For Operation Of The Device - Messko MLog IM50 Instrucciones De Servicio

1

General

1 General
1.1

Safety notes

All persons involved with the fitting and operation of the
device must be
- adequately professionally qualified and
- strictly observe these operating instructions .
Perfect function is not guaranteed in the event of incor-
rect configuration or fitting.
Notes are used in these operating instructions to em-
phasize important information .
NOTE
refers to important information on a specific topic.
1.2

Intended use

The MESSKO MLog transport monitor IM50/IM100 is
® ®
used for monitoring the transport and status of all types
of goods .
The transport monitor is firmly attached to a cargo item
so that during the transport it can record the accelera-
tion values, for example, via sensors . If set limit values
are exceeded, the data are permanently stored and
the violation of limit is displayed on the device . In this
way, loads that are detrimental to the cargo item can be
identified in good time during a transport. The course of
the transport can be visualized . Monitored goods may
be: Heavy loads, e .g . power transformers, generators,
satellites, paper rolls, etc . .
It is imperative in use to observe and comply with the
limit values shown on the rating plate and specified in
the operating instructions prior to commissioning the
device .
1.3

Notes for operation of the device

It is imperative that the user complies with the national
accident prevention regulations and installation regu-
lations .
NOTE
Installation and commissioning should only be
carried out in accordance with these operating
instructions .
The operator shall ensure that the device is used
for its intended purpose .
BA3431002/04 ES-EN
1.4 Variants of the MESSKO
The device is available in two versions IM50 and IM100
with the following extension stages:
• MLog IM50
- Measurement of the acceleration in X, Y and Z
direction
- Measurement of the ambient air temperature
- Measurement of the ambient humidity
- Recording of the GPS position (optional)
• MLog IM100
- Measurement of the acceleration in X, Y and Z
direction
- Measurement of the ambient air temperature
- Measurement of the ambient humidity
- Recording of the GPS position (optional)
- Display
- 6 universal inputs (optional)
- 2 digital inputs (optional)
- Bluetooth module (optional)
- GSM module (optional)
MLog
® ®
17