Home Decorators Collection 7983HDCBN Guía De Uso Y Cuidado página 15

Assembly — Installing the Light Kit (continued)
Attaching the LED light kit
13
and plastic shade
CAUTION: Before starting installation, disconnect the
power by turning off the circuit breaker or removing the fuse
at the fuse box. Turning power off using the fan switch is not
sufficient to prevent electric shock.
□
Remove one of the three light kit mounting screws (II)
from the light kit mounting plate (I) and loosen the
other two screws (II). (Do not remove.)
□
While holding the 24W LED light kit (J) under the fan
motor assembly (F), make the 2-pin wire connections
(PP):
- White to white
- Black to blue
□
Place the key holes in the 24W LED light kit (J) over
the two mounting screws (II) previously loosened
from the light kit mounting plate (I). Turn the 24W
LED light kit (J) until the 24W LED light kit (J) locks in
place at the narrow section of the key holes. Secure
by tightening the two light kit mounting screws (II)
previously loosened and the one (II) previously
removed.
□
Position the notches (RR) in the outer rim of the
plastic shade (K) so they line up with the tabs (QQ) on
the inside of the rim on the 24W LED light kit (J).
Carefully lift the plastic shade (K) up inside the 24W
LED light kit (J) and secure it to the fan by turning the
plastic shade (K) clockwise until snug. DO NOT
OVERTIGHTEN.
QQ
RR
15
Please contact 1-800-986-3460 for further assistance.
F
PP
I
II
HOMEDEPOT.COM/HOMEDECORATORS
J