Dometic PERFECTWALL PW1500 Instrucciones De Montaje página 13

PW1500, PW1750
➤ Fasten the awning using a countersunk bolt, counter plate, serrated lock washer
and hexagon nut (fig. i, page 2).
➤ Insert the cover caps on the counter plates (fig. e, page 2).
➤ Retract the awning completely using the crank.
Installing the wall bracket
The wall bracket must be installed if the awning is to be attached to the side of the
vehicle when extended.
➤ Select the location of the installation.
➤ Mark where the holes are to be drilled.
➤ At the marked points, drill holes with a diameter of 3 mm from the outside into
the external wall (fig. j, page 2).
➤ Put the upper and lower sections of the wall bracket together.
➤ Clean the outer sides of the lower section and the installation surface in the
vehicle.
I
NOTE
Make sure that no glue gets on to the movable upper section of the wall
bracket.
➤ To glue and seal, apply an elastic adhesive, such as Sikaflex
the back of the wall bracket.
➤ Fasten the wall bracket with drill screws (fig. j, page 2).
or
➤ Rivet the wall bracket (fig. j, page 2).
Installing the crank bracket
➤ Mount the wall bracket for the crank at a suitable location inside the vehicle
(fig. k, page 2).
EN
All manuals and user guides at all-guides.com
Installing the awning
®
-221 for example, to
11