Metabo SB 710 Manual Original página 13

17027063_1110 SB_Bauk10.book Seite 13 Dienstag, 23. November 2010 2:03 14
8 Use
8.1 Adjusting depth stop
Release additional handle (2). Set depth stop (3) to
the desired drilling depth and retighten additional
handle. (2)
8.2 Setting direction of rotation, transport
lock (switch-on lock)
(except SB 710)
Do not activate the rotation selector switch
(11) unless the motor has completely
stopped.
See page 3 (please unfold).
R = Clockwise setting
L = Counter-clockwise setting
0 = Central position: transport lock setting
(switch-on lock)
The drill chuck must be firmly screwed onto
the spindle and the safety screw inside the
drill chuck (if applicable / model-specific) must be
firmly tightened with a screwdriver. (Caution, left-
handed thread !) If rotated counterclockwise (e.g.
when screwing) it could otherwise become loose.
8.3 Setting up drilling, impact drilling
Press the slide switch (7).
= Impact drilling
= Normal drilling without impact
Note: Impact drilling and drilling, only in clock-
wise direction
Note: When impact drilling, use a high speed:
Select 2nd gear on thumbwheel (1).
8.4 Selecting a gear
Select the desired gear by turning the thumbwheel
(1).
Change speed only when the machine is in the
process of running down (briefly switch it on and
off).
1st gear (low speed, high torque) e.g. for
screwdriving, drilling
2nd gear (high speed) e.g. for drilling, impact
drilling
All manuals and user guides at all-guides.com
8.5
Use the setting wheel (8) to preselect the
maximum speed. See page 4 for recommended
drilling speeds.
8.6
Set using setting wheel (9) (position 1 - 6). When
the preselected torque is reached, the motor
stops.
1 = When a low torque is reached, the motor
6 = When a high torque is reached, the motor
+ = Drill setting - not torque control (for max.
8.7
Set using setting wheel (9).
+
8.8
Switching on, speed: press the trigger (13).
The speed can be changed by pressing in the
trigger.
The electronic soft start means that the
machine accelerates continuously until the
preselected speed is reached (depends on
equipment).
Release the trigger to switch off.
Continuous activation: While pressing on the
trigger (13), press in the locking button (12) and
then release the trigger. To switch off, press
and release the trigger (13) again.
your hands. Therefore, always hold the
machine with both hands using the handles
provided, stand in a safe position and concen-
trate.
8.9
See illustrations A on page 3.
ENGLISH
Preselect speed
(except SB 710)
Setting up torque control
(SBE 900 Impuls)
stops.
stops.
torque)
Switching on impulse function
(SBE 900 Impuls)
= Impulse function always switched on
= Impulse function off (for drilling)
Switching on/off, changing speed
In continuous operation, the machine
continues running if it is forced out of
Tool change with Futuro Top keyless
chuck (6)
ENG
13