Hopper
capacity (g)
Height (mm)
Width (mm)
Depth (mm)
Ton: 60 s
Toff: 600 s
3–2. SECURING THE CONTAINER
Before starting, mount the coffee bean
container (2).
Insert the container (2) into its seat
(Fig. A), positioning it so that the hole is
aligned with the screw on the back of
the appliance.
Tighten the locking screw (9) (Fig. B).
4. USE
4–1. STARTING THE APPLIANCE
Carefully unpack the appliance and
remove all the packaging materials
and promotional labels
Before starting the appliance:
• Insert the container (2) into its seat
(Fig. A), positioning it so that the hole is
aligned with the screw on the back of
the appliance.
• Tighten the locking screw (9) (Fig. B).
• Insert the filter holder clip (7) (Fig. E)
into the appropriate hole.
• After plugging in the appliance, pull the
tab (3) at the base of the coffee bean
container (2) to close it (Fig. C).
• Remove the lid (1) from the container
(2) and fill it with coffee beans.
• Replace the lid (1) and pull the tab (8)
to allow the coffee beans to pass.
• The machine has to be set up before
use according to the type of coffee
blend (more or less roasted) and the
degree of grinding.
• Decide the type of coffee blend (more
or less roasted).
• Decide the degree of grinding.
600
4–2. SWITCHING ON THE MACHINE
410
154
230
• Switch on the coffee grinder by
pressing the on/off switch (10).
• When turned on, the display loads
the firmware and prepares to deliver
ground coffee.
• Select the required dose by pressing
the single dose (15) or double dose
(16) button on the display.
• Coffee delivery will start with a single
(quick) press of the start grinding
button (6).
• Once the ground coffee has been
dispensed, the grinding time returns to
the set value. The dose counter (single
or double) increases by 1.
17
When appliance is first switched
on, it is set to the factory settings.
Then next time it is switched on, it
will maintain the settings prior to
being switched off.
To ensure that the appliance
operates correctly, avoid grinding
more than 160g of coffee at a
time.
To pause automatic dispensing
before the grinding time has
finished, press the start grinding
button with the filter holder (6):
• Press the button (6) again
to resume dispensing for the
remaining time.
• Press and hold the button of the
selected dose (flashing) to stop
dispensing. The grinding time
returns to the set value.