Worx WX800. Serie Manual Original página 11

from the same store that sold you the tool. Refer to the
accessory packaging for further details. Store personnel
can assist you and offer advice.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
INTENDED USE:
The machine is intended for cutting, roughing and
brushing metal and stone materials without using water.
For cutting metal, a special protection guard for cutting
(accessory) must be used.
ASSEMBLY AND OPERATION
Action
BEFORE OPERATION
Removing the battery pack
Charging the battery pack
Installing the battery pack
WARNING: When replacing
the battery pack, do not
insert the battery until the
Grinding/Cutting Disc comes to
a complete stop!
ASSEMBLY
Assembling Auxiliary Handle
Assembling Grinding/Cutting Disc
Lithium-Ion cordless angle grinder
Adjusting Wheel Guard
NOTE: Before any work on the
machine itself, remove the
battery pack. For work with
grinding or cutting discs, the
protection guard must be
mounted. Use the correct type
of disc for your application. If
the power tool is intended to
perform cutting off operations,
a guard specific for this
operation must be fitted.
The coded projection on the wheel
guard ensures that only a guard
that fits the machine type can be
mounted.
Open the clamping lever (13).
Place the wheel guard with coded
Figure
projection into the coded groove
on the spindle of the machine head
and rotate to the required position
(working position).
See Fig. A1
To fasten the wheel guard, close
the clamping lever (13).
See Fig. A2
The closed side of the wheel
guard must always point to the
operator.
See Fig. A3
OPERATION
Using On/Off Switch
Hand Grip Areas
Rough Grinding
See Fig. B
See Fig. C1, C2, C3
Cutting
WORKING HINTS FOR YOUR
ANGLE GRINDER
1. Always start at no load to achieve maximum speed
2. Do not force the disc to work faster, reducing the Disc's
3. Always work with a 15-30 angle between disc and
4. When using a cutting disc never change the cutting
5. When cutting very hard material best results can be
6. When using a diamond disc it will become very hot. If
WARNING! Never use a
cutting disc for roughing.
then start working.
moving speed means longer working time.
workpiece. Larger angles will cut ridges into the
workpiece and affect the surface finish. Move the
angle grinder across and back and forth over the
workpiece.
angle otherwise you will stall the disc and angle
grinder motor or break the disc. When cutting, only cut
in the opposite direction to the disc rotation. If you cut
in the same direction as the disc rotation the disc may
push itself out of the cut slot.
achieved with a diamond disc.
See Fig. D
See Fig. E
11
See Fig. F
See Fig. G
EN