Fagor BV-2006 NX Manual De Instrucciones página 9

All manuals and user guides at all-guides.com
attempt to repair. If a repair is required,
contact a Technical Assistance Service
authorised by the manufacturer and
request the use of original spare parts.
• If the cable for this appliance is
damaged, contact an authorised
Technical Assistance Service for it to be
replaced.
• Do not leave the appliance exposed to
the elements (rain, sun, ice, etc.).
• Do not use or let any part of the
appliance come into contact or near
hot surfaces (kitchen gas or electric
hobs or ovens).
• Do not use detergents or abrasive
sponges to clean the appliance.
• Do not touch the hot surfaces. Use the
handles.
• Do not let the cable come into contact
with the hot parts of the appliance.
• The blade is very sharp. Handle it
carefully to avoid cuts.
• Do not fill the blender any higher than
the maximum level.
• Do not remove the jug from the motor
base when the appliance is functioning.
• Ensure the jug lid is properly fitted
before using the blender.
• Do not place your hands or any objects
in the jug when the blender is functioning.
If necessary, disconnect the appliance
and use a spatula to remove any food
stuck to the walls of the jug.
• Do not submerge the motor base in
water or any other liquid.
• Do not touch the rotating parts while
they are in movement. Always wait for
them to stop.
• This appliance must only be used for
processing food.
4. OPERATING INSTRUCTIONS
Before using the blender for the first time,
clean the dispenser cap, jug lid, jug and
blade in warm soapy water and dry them
thoroughly before assembling them again.
ASSEMBLY
Unplug the appliance before carrying out
any dismantling or assembly operations.
1. Place the rubber seal (4) on the edge of
the blade unit (5) (fig. B)
2. Insert the blade unit (5) in the joint (6)
(fig. C)
3. Screw the bottom part of the glass jug
(3) onto the joint (6) and turn it anti-
clockwise (fig. D).
4. Place the assembled jug on the motor
base (7) (fig. E).
5. Firmly close the lid (2) (fig. F).
6. Place the dispensing cap (1) in the hole in
the lid and turn it anti-clockwise (fig. G).
To dismantle the blender, to clean it for
example, carry out the assembly process in
reverse order.
ADJUSTMENT
• Place the assembled blender on a flat,
stable surface.
• Before plugging in the blender, make
sure the jug is correctly fitted and in
place on the motor base (7).
NOTE: The blender has a safety lock
system to ensure the appliance can only be
connected if the accessories are correctly
fitted to the unit.
• Make sure the dial (8) is turned to OFF.
Unwind the cable from the base and
plug in the blender.
• Open the lid (2) or the dispenser cap (2)
by turning them clockwise and pour the
food or drink for blending into the jug.
• Tightly close the lid (fig. F) and fit the
dispenser cap, turning it anti-clockwise
(fig. G).
FUNCTIONING
Connect the blender by turning the dial (8)
to ON. The pilot lights on the three buttons
will flash (fig. H). You may adjust the
rotation speed or make a quick selection,
depending on your requirements:
• Speed regulator: Select the speed by
turning the dial (8) between MIN and
MAX, if you wish to control the rotation
speed yourself. The pilot lights will light
up until the selected position is reached
and the indicator lights on the three
buttons will switch off (fig. I).
• Quick select: Press one of the three
quick select buttons, depending on
your requirements. The corresponding
8