High-Speed Sync; Second-Curtain Sync - Hahnel MADUS 600RT Manual De Instrucciones

All manuals and user guides at all-guides.com
• If the subject is too far away and underexposure, the < > icon will blink
in the viewfinder. Move closer to the subject and try the FE lock again.
• If <ETTL> is not displayed on the LCD panel, FE lock cannot be set.
• If the subject is too small, FE lock might not be very effective.

High-Speed Sync

High Speed Sync (FP flash) enables the flash to synchronize with
all camera shutter speeds. This is convenient when you want to use
aperture priority for fill-flash portraits.
• If you set a shutter speed that is the same as or slower than the camera's
maximum flash sync speed, <
• With high-speed sync, the faster the shutter speed, the shorter the
effective flash range
• To return to normal flash, press
• Multi flash mode cannot be set in high-speed sync mode
• Over-temperature protection may be activated after 15 consecutive high-
speed sync flashes

Second-Curtain Sync

With a slow shutter speed, you can create a light train following the
subject. The flash fires right before the shutter closes.
18
retained in memory
• Each time the <FEL> button
is pressed, a preflash will
be fired and a new flash
exposure setting will be
locked
1. Press Function Button 4 <
> so that < > is
displayed
2. Check that < > is
displayed in the viewfinder
> will not be displayed in the viewfinder
< >
button twice
1. Press function button 4 <
> button so that <
is displayed on the LCD panel.
2. To return to normal flash
press the function button 4 <
> button.
Modus 600RT
>