Setting Camera Flash Functions; Protection Functions - Hahnel MADUS 600RT Manual De Instrucciones

All manuals and user guides at all-guides.com

Setting Camera Flash Functions

The following flash functions are settable according to different flash
modes.
1. Flash mode
2. Shutter sync (1st/2nd curtain,
high speed sync)
3. FEB
4. Flash exposure compensation
5. Flash firing
Clear All Flash Custom Functions
Flash C.Fn settings
Auto powe off
0:Enabled
1:Disabled
-
0 1 2 3 4 5 6 7 8 9 10 11 12 13
0 0 0 0 0 0 0 0 0 0 0 0 0 0
• If flash exposure compensation has already been set with the speedlight,
flash exposure compensation cannot be set with the camera. To set it
with the camera, the speedlight flash exposure compensation must be
set to zero
• If any Flash Custom Functions and flash settings other than flash exposure
compensation have been set by both the camera and the flash, the latest
settings will take effect.
Protection Function
1. Over-Temperature Protection
• To avoid overheating and deteriorating the flash head, do not fire
more than 30 continuous flashes in fast succession at 1/1 full power.
After 30 continuous flashes, allow a rest time of at least 10 minutes
• If you fire more than 30 continuous flashes and then fire more
flashes in short intervals, the inner over-temperature protection
function may be activated and make the recycling time over 10
seconds. If this occurs, allow a rest time of about 10 minutes, and
the flash unit will then return to normal
• When the over-temperature protection is active, <
the LCD display
Modus 600RT
6. Clear camera flash's settings
7. Custom Functions of Camera
Flash C.Fn-
00, C.Fn-01, C.Fn-03,
C.Fn-04, C.Fn-08, C.Fn-10,
C.Fn-20 and C.Fn-22.
Flash function settings
screen
Flash C.Fn settings screen
1
* Screens from the EOS-1D Mark III.
> is shown on
39