Andis PFS-1 Manual Del Usuario página 4

SAVE THESE INSTRUCTIONS
OPERATING INSTRUCTIONS
CHARGING SHAVER
The shaver has not been charged at the factory. Please charge the shaver for a
minimum of 60 minutes before the first use for maximum performance.
This battery charger is intended for use with Andis model PFS-1 lithium-ion battery with
a rated capacity of 3.6V
carton. Plug the adapter into a 100-240V AC outlet, or according to your local power
standards. Note that the shaver must be turned off for the battery to charge. Plug the
cord adapter directly into the inlet on bottom of shaver (Figure A). The white LED bars
cycle through one by one while charging. Three solid white bars indicate the battery is
fully charged (Figure A). The shaver will not operate while charging.
WET/DRY OPERATION
Product can safely be used in the shower and with water or shaving cream.
TRAVEL LOCK FEATURE
This product is equipped with a travel lock feature (Figure A). To enable the travel lock,
press and hold the power button for 5 seconds or until you see the white light below the
lock symbol turn on. To release the travel lock, press and hold the power button for
5 seconds until the shaver turns on.
Battery charging
Battery fully charged
Travel lock engaged
SHAVER IN USE
Battery fully charged
Battery 60% full
Battery 30% full
Low battery, should be recharged
4
1400mAh. Remove the shaver and AC adapter from the
SHAVER INDICATOR LIGHTS
Cycling white bars
3 solid white bars
White travel lock indicator when power button is pressed
3 white bars
2 white bars
1 white bar
1 red bar