Brandson Equipment 304577 Manual Del Usuario página 38

Replacing the outdoor sensor battery
Each time the batteries of the wireless 5-IN-1 sensor are replaced, a
manual re-pairing has to be carried out.
1. Open the battery compartment of the outdoor sensor.
2. Replace all the batteries in the sensor with new ones.
3. Press and hold the "LIGHT/SNOOZE" button on the main unit for
about 5 seconds.
4. Press the "RESET" button on the 5-IN-1 sensor outdoor sensor.
5. The outdoor sensor and the weather station should be connected
within the next few minutes. If this does not happen, repeat this
process.
6.3 Reconnecting the outdoor sensor
Press and hold the "LIGHT/SNOOZE" button for 5 about seconds. The
weather station then scans again for the outdoor sensor.
9. Basic settings
The weather station gets the date and time via the Internet server after
you connect the device to your WiFi. Further details about this are given
later in this user manual. You can also set the time and date manually.
1. Press and hold the "SET" button in normal mode for about 2 seconds
to access the settings.
2. Adjust the value using the "WIND" (+) or "PRESSURE" (-) buttons. The
adjusted value is confirmed by pressing the "SET" button.
3. The setting cycle is as follows:
• Beep On/Off
• Record daily values MAX/MIN on/off
• 12 or 24 hour display
• Hour
• Minute
• Date format
38
English