Brandson Equipment 304577 Manual Del Usuario página 42

5. First, you need to set the time alarm. Set the desired alarm time and
confirm the settings using the "SET" button.
6. You then set the following alarms one after the other. Confirm the
alarm entry using the "SET" button. Press the "ALARM" button in the
alarm setting if you want to enable the alarm. The setting cycle is
given below:
• Time
• Maximum indoor temperature
• Minimum indoor temperature
• Maximum relative humidity indoors
• Minimum relative humidity indoors
• Maximum outdoor temperature
• Minimum outdoor temperature
• Maximum relative humidity outdoors
• Minimum relative humidity outdoors
• Maximum wind
• Maximum wind gusts
• Maximum amount of rainfall per hour
• Maximum rainfall during the day
Switching off the alarm
• The alarm stops automatically after 2 minutes if the device is not oper-
ated. The alarm is re-activated on the next day.
• Press the "SNOOZE" button briefly to enable the snooze function, so
the alarm will go off again after 10 minutes.
• The alarm is stopped and re-activated the next day by pressing and
holding the "SNOOZE" button for 2 seconds.
• The alarm is stopped by pressing the "ALARM" button and the alarm is
re-activated the next day.
42
English