Makita XBU02 Manual De Instrucciones página 6

Switch action
CAUTION:
• Before inserting the battery cartridge into the
tool, always check to see that the switch trigger
actuates properly and returns to the "OFF"
position when released.
► 1. Switch trigger
To start the tool, simply pull the switch trigger. Tool
speed is increased by increasing pressure on the switch
trigger. Release the switch trigger to stop.
► 1. Lock button
For continuous operation, pull the switch trigger, push in
the lock button and then release the switch trigger.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
1
1
1
Speed change
1
► 1. Adjusting dial
The maximum air volume can be adjusted just by
turning the adjusting dial. This can be done even while
the tool is running. The dial is marked 1 (lowest) to 6
(highest).
NOTICE:
The speed adjusting dial can be turned only as far
as 6 and back to 1. Do not force it past 6 or 1, or
the speed adjusting function may no longer work.
When working in a high temperature circum-
stance, the tool may be stopped because of the
overheat protection system. In that case let the
tool cool down. Avoid setting to speed 6 (highest)
in high temperature circumstances.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
the battery cartridge is removed before carrying
out any work on the tool.
Installing the long nozzle
2
► 1. Long nozzle 2. Triangle marking
To install the long nozzle:
1. Align the small projection of the housing with the
groove of the long nozzle.
6 ENGLISH
2
1