Unpacking And Preparation - Ruby Kero KSP-240A Manual De Utilización

Remember that this heater is designed for occasional use and should never be left operating without proper
monitoring.
You should always be present in the room during operation of the heater.
Turn the heater off, making sure that it is properly extinguished if you have to leave the room and before
going to bed.
It is not designed for heating or cooking food or for drying clothing or any other objects.
Do not put anything on or in front of the appliance.
CAUTION: The top is neither too hot nor too cold, but the grille is very hot. Keep out of reach of children.
1. Open the carton, remove the pump.
2. Take the equipment out and remove the side wedges.
3. Open the protection grill (4 in figure A), grasping it on the right (lift and pull) and take out the burner,
starting by sliding the upper carton that you will then remove downwards, and remove the lower wedge.
4. Put the burner back in place and make sure it is correctly positioned. To do this, grasp the metal spring
attached to the base and move it until it is properly set (figure B).
5. Close the grill by working in the opposite direction (engage the vertical right-hand bar in the upper hole,
lift, push then allow to descend in the lower hole).
6. Open the cover providing access to the tank (2 on figure A) and remove the wedge under the cover.
7. Stow away all the packing parts that you have just removed from the original carton, which should be kept
dry during the heating season.
8. Open the cover of the rear housing (figure C) and install two R20 batteries, ensuring that the polarities (+)
and (-) are as indicated, then close the cover.
Remove the batteries if the appliance is to be left unused for some time.
9. Test the stopping system as follows:
- Bring the wick to the high position using the knob provided for the purpose (7 of figure A). NB: If the tank
is not in position, you will be unable to carry out this operation, as this appliance was designed for
intermittent use, and lack of a tank prevents it from functioning.
- Press the stop button (8 of figure A) to lower the wick.
To make sure the wick has descended properly, try turning the knob (7 of figure A) in the counterclockwise
direction; if you are unable to do so, it means that the stopping system is working correctly.
USE
AVOID ALL CONTACT WITH THE GRILLE

UNPACKING AND PREPARATION

15