HoMedics HTD8216C Manual De Usuario página 13

Forehead temperature measurement
figure 6
1. Turn on the thermometer by pressing the Start button. The thermometer will
perform self-test with all segments displayed for 2 seconds. See figure 6.
2. After full display over, you will hear "beep beep beep", which means that the
self-test is complete. The last measured temperature will be displayed. If no data
is saved to memory, the display will indicate "----". See figure 7.
3. Please note, if the screen shows this symbol instead of
cover and press the MODE button to switch to forehead mode. See figure 8.
4. After initialisation, the memory symbol "M" will disappear and the unit symbol
°C (or symbol °F) will start flashing which means the device is ready to take a
temperature measurement.
5. Temperature scan method: keep the thermometer vertical and close to the
forehead. Press the Start button. The device will start measuring with a short
"beep" once at the start, then 3 - 10 seconds later. Finally a long "beep" or 5
short "beeps" means measurement has been completed, and the target value of
the measured temperature (maximum) will display on the LCD. The LCD backlit
colour will change to red, yellow or green. Green means the Normal Temperature
and ready for measurement . Yellow means Slight Fever. Red indicates High Fever.
Please kindly note that both yellow and red colour are a warning.
Mode conversion
The product will switch to ear mode if the cap is removed. When the cap is replaced,
forehead mode and surface mode can be switched between using the MODE button. "ear
" and "forehead" mode is used for measuring human body temperature, the "surface "
mode is used to measure the surface temperature. (The factory default is "body" mode).
figure 7
GB | 13
figure 8
, remove the battery