Dry Ironing - Black and Decker DIGITAL ADVANTAGE D2030 Manual Del Usuario

SURGE OF STEAM
Horizontal
Tip: Use to remove stubborn creases.
1. With the water tank filled to the MAX mark, set temperature setting and variable
steam to the appropriate settings for your fabric. See fabric guide on the iron and read
garment's label to help you determine fabric type.
2. For best performance, press the steam
3. When finished ironing, turn the variable steam dial to the steam off
unplug the iron.
Important: Always stand the iron on its heel rest when powered on but not in use.
Vertical
Tip: Use for removing wrinkles from hanging clothes and drapes.
1. With the water tank filled to the MAX mark, set temperature setting and variable
steam to the appropriate settings for your fabric. See fabric guide on the iron and read
garment's label to help you determine fabric type.
2. Hang the garment to be steamed on a clothes hanger. (Curtains or drapes can be
steamed once they are hung.)
3. Hold the iron close to, but not touching, the fabric.
4. Pull the fabric tight in your free hand and pump the steam
iron over the fabric.
5. When finished ironing, turn the variable steam dial to the steam off
unplug the iron.

DRY IRONING

1. To iron without steam, set the variable steam dial to steam off
USING SPRAY
Tip: Use to dampen tough wrinkles at any setting.
1. Be sure the iron is filled with water.
2. On first use, pump the spray
10-MINUTE AUTO SHUTOFF
The automatic shutoff feature in your iron works as follows:
• Once the iron reaches appropriate temperature, it will turn off after 10 minutes of
inactivity. Before turning off, the iron will beep once and "AUTO OFF" will flash in the
digital display.
• Once turned off, the digital display will go dark, but the words "AUTO OFF" will
continue to show in the display.
• As soon as you pick up the iron, it will beep once and start heating again to the set
temperature setting. Wait for iron to reheat completely before resuming operation.
• To turn the iron off manually, press the power / temperature setting button for
2 seconds; this can be done from any temperature setting.
EMPTYING WATER TANK (OPTIONAL)
Note: It is not necessary to empty the water after each use.
1. Unplug the iron and let it cool.
2. To empty the water, hold the iron over a sink with the tip pointing down. Water will
empty out the water-fill opening.
6
All manuals and user guides at all-guides.com
button several times.
button at 5-second intervals.
setting and
button as you move the
setting and
.