Double Insulation; Additional Safety Rules - Makita HM1200 Manual De Instrucciones

ENGLISH
1 Bull point
2 Tool retainer
3 Notched portion
4 Side grip
5 Clamp nut
SPECIFICATIONS
Model
Blows per minute .................................................................................. 2,000
Overall length ........................................................................................ 480 mm
Net weight ............................................................................................. 8.3 kg
• Due to the continuing program of research and
development, the specifications herein are subject
to change without prior notice.
• Note: Specifications may differ from country to
country.
Power supply
The machine should be connected only to a power
supply of the same voltage as indicated on the
nameplate, and can be operated on single-phase
AC/DC supply. They are double-insulated in accor-
dance with European Standard and can, therefore,
also be used from sockets without earth wire.
Safety hints
For your own safety, please refer to enclosed safety
instructions.
These symbols mean:
Read instruction manual.

DOUBLE INSULATION

ADDITIONAL SAFETY RULES

1. Wear a hard hat (safety helmet), safety glasses
and/or face shield. It is also highly recom-
mended that you wear a dust mask, ear pro-
tectors and thickly padded gloves.
2. Be sure the bit is secured in place before
operation.
3. Under normal operation, the machine is
designed to produce vibration. The screws
can come loose easily, causing a breakdown
or accident. Check tightness of screws care-
fully before operation.
All manuals and user guides at all-guides.com
Explanation of general view
6 Side handle
7 Switch trigger
8 Hex wrench
9 Rear cover
0 Screwdriver
q Brush holder cap
w Lock nut wrench
e Crank cap
HM1200
4. In cold weather or when the machine has not
been used for a long time, let the machine
warm up for several minutes by operating it
under no load. This will loosen up the lubrica-
tion. Without proper warm-up, hammering
operation is difficult.
5. Always be sure you have a firm footing.
Be sure no one is below when using the
machine in high locations.
6. Hold the machine firmly with both hands.
7. Keep hands away from moving parts.
8. Do not leave the machine running. Operate the
machine only when hand-held.
9. Do not point the machine at any one in the
area when operating. The bit could fly out and
injure someone seriously.
10. When chipping into walls, floors or wherever
"live" electrical wires may be encountered, DO
NOT TOUCH ANY METAL PARTS OF THE
MACHINE!
Hold the machine by the insulated grasping
surfaces to prevent electric shock if you chip
into a "live" wire.
11. Do not touch the bit or parts close to the bit
immediately after operation; they may be
extremely hot and could burn your skin.
SAVE THESE INSTRUCTIONS.
HM1200B HM1200K
2,000 2,000
490 mm 490 mm
9.4 kg 9.1 kg
3