Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Door Adjustment
The cabinets are designed with adjustable doors.
1.
Place the cabinet in the desired location.
2.
Check to see whether the doors need adjusting. It is more often the
left door that will need to be aligned.
3.
Using a Phillips screwdriver, loosen all the screws attaching the hinge
to the cabinet.
4.
Adjust door to the desired height.
5.
Tighten the screws.
Locker Shelves
Install Shelves
NOTE: Plan the shelf heights and install the shelves starting from the
bottom. The shelves are supported by the metal tabs on the side walls of
the cabinet.
1.
Determine the placement of the shelves.
2.
Tilt the shelf so that one end is higher than the other as shown.
2
1. Push down
2. Lift up
3.
Insert the shelf into the cabinet so the higher end is directly above the
desired metal tabs. Push down to snap the shelf edge into place
behind the side tabs.
NOTE: As the lower end is pushed upward, it presses on the metal
tab, allowing it to pass.
4.
Raise the lower end so it is directly above the desired tab and push
down to snap shelf edge into place behind the side tab.
5.
Make sure the shelf edges are in place behind all the tabs and the
shelf is firmly supported.
6.
Repeat this process for the other shelves.
Remove Shelves
1.
Lift up on the underside of the shelf until the shelf edges are free of
the cabinet tabs.
2.
Tilt the shelf to reposition it within the cabinet or to remove it from the
cabinet.
4
All manuals and user guides at all-guides.com
Place one end of the steel clothes bar in the left-hand side bracket and
lower the other end into the right-hand side bracket as shown.
Using a Phillips screwdriver and (6) ¹⁄₄ in.—20 x ¹⁄₂ in. pan-head screws
(provided), attach the 3 storage bins to the inside of the right-hand door.
NOTE: Use 2 screws to attach each storage bin and fully tighten the
screws.
1
1.
2.
3.
Install Features
Install Clothes Bar
Install Bins
1
1. Pan-head screw
Install Adjustable Mirror
Using a Phillips screwdriver and (2) ¹⁄₄ in.—20 x ¹⁄₂ in. pan-head
screws (provided), attach both sides of the mirror to the inside of the
left-hand door.
Adjust the tilt of the mirror to the desired angle and fully tighten the
screws.
Remove the protective paper film from the mirror.
1
2
1. Protective paper film
2. Pan-head screw
2
Publicidad
Tabla de contenido
