Home Zone Security MK-SC0108 Manual Del Usuario página 3

PRE-INSTALLATION (Continued)
Tools Required for Installation (not included)
Safety
Drill
goggles
C
A
B C
FIXTURE PACKING LIST
Part Description
A Light Fixture
B Plastic Wall Plug
C Decorative Cover
D Mounting Plate
E Mounting Screw
User Manual
For further questions or assistance, please visit our website www.homezonesecurity.com.
04
Silicone
Phillips
Level
Sealant
screwdriver
E D B
D E E
Quantity
1
2
1
1
2
1
INSTALLATION
WARNING: Risk of electric shock. Disconnect power at fuse or circuit breaker
!
before installing or servicing.
Step 1. Mounting the Mounting Plate
Line up the Mounting Plate (D) to the required position mark and then drill suitable size
holes. If you are mounting to a wall use the Plastic Wall Plugs (B) supplied. Please note if
mounting to a brick wall holes should be drilled into the brick and not the mortar course.
All electrical work carried out in England and Wales must conform to the current IET Wiring
Regulations: BS 7671:2018 and Part P of the Building Regulations 18th edition. The light
fixture should be connected to a lighting circuit with the minimum protection of 6A MCB at
the consumer unit via a 10A wall switch. All connections to the consumer unit should be
made by a qualified electrician. Alternatively the lamp fitting can be fitted with a 3 core flex
connected to a 13A 3 pin plug with a 5A fuse and plugged into an existing switched mains
socket.
Before mounting the Mounting Plate (D), pierce the plastic insert in the cable and thread the
mains connecting cable through the cable entry.
Mount the Mounting Plate (D) using the Mounting Screw (E) supplied. Tighten the left hand
screw first then level the Mounting Plate (D) before tightening the right hand screw.
Step 2. Wiring the Light Fixture
! CAUTION: Make sure polarity is correct as shown below.
Prepare the ends of mains cable leaving enough cable length to make it easy to make
connections.
Connect the mains cable to the Connector Block.
Insert the blue wire from the original power supplier
into the terminal marked "N".
Insert the brown wire from the original power supplier
into the terminal marked "L".
Insert the green / yellow earth wire from the original
power supplier into the terminal marked " ".
05