Care And Cleaning; Troubleshooting - Home Zone Security MK-SC0108 Manual Del Usuario

ADVANTAGES OF LED'S
1. Energy saving – much lower power consumption and money savings.
2. Longer lifetime – Solid State lighting has no filament to break.
3. Light does not radiate heat.

CARE AND CLEANING

To prolong the original appearance, clean with clear water and a soft, damp cloth only.
Do not use paints, solvents, or other chemicals on this light fixture. They could cause a
premature deterioration of the finish. This is not a defect in the finish and will not be
covered by the warranty.
Do not spray with a hose or power washer.
2 YEAR LIMITED WARRANTY
WHAT IS COVERED
This product is guaranteed to be free of factory defective parts and workmanship for a period
of 2 years from date of purchase. Purchase receipt is required for all warranty claims.
WHAT IS NOT COVERED
This guarantee does not include repair service, adjustment and calibration due to misuse,
abuse or negligence, or LEDS. Unauthorized sevice or modification of the product or of any
furnished component will void this warranty in unauthorized service, or return shipping
charges. This warranty is not extended to other equipment and components that a customer
uses in conjunction with this product.

TROUBLESHOOTING

Problem Possible Cause
The light will not come on. The light switch is turned off.
The fuse is blown or the circuit breaker
is turned off.
The light fixture is not properly attached
to the mounting plate, if this is a new
installation (the pins are not fully
seated in the terminal block).
The circuit wiring is incorrect, if this is a
new installation.
The detector is aimed in the wrong
direction.
The power voltage is wrong.
The light comes on during The detector may be installed in a
relatively dark location.
the day.
The Ambient Light (LUX) level setting
is wrong.
10
Solution
Turn the light wall switch on.
Replace the fuse or turn the circuit
breaker on.
Re-install the light fixture to the
mounting plate and ensure the pins are
fully seated in the terminal block.
Verify the wiring is correct.
Re-aim the detector to cover the desired
area.
Verify that the power voltage is correct.
The light fixture is operating normally
under these circumstances.
Adjust the Ambient Light (LUX) level
setting to " " position.
Problem Possible Cause
The lights stay on continuously. A bulb is positioned too close to the
detector or pointed at nearby objects
that cause heat to trigger the light
detector.
The light fixture is on Manual Override
Mode.
The light fixture is on the same circuit
as a motor, transformer, or fluorescent
bulb.
The light comes on for no There is motion in the detection zone.
apparent reason.
The light fixture is wired through a
dimmer or timer.
Waste electrical and electronic products should not be disposed of
with household waste. Please recycle where facilities exist. Check
with your Local Authority for recycling advice.
This product contains three light sources of energy efficiency class E
HomeZone Security
Test Rite Products Corporation
1900 S. Burgundy Place
Ontario, CA. 91761 U.S.A
Service English, French, Spanish
acs@americancustomerservice.com
www.homezonesecurity.com
Solution
Reposition the bulb away from the
detector or nearby objects.
Adjust the light fixture to Auto Mode.
Install the light fixture on a circuit without
motors, transformers, or fluorescent
bulbs.
Make sure the detector is not picking up
moving objects such as trees, traffic, etc.
and re-aim the detector.
Do not use a dimmer or timer to control
the light fixture. Replace the dimmer or
timer with a standard on/off wall switch.
Non-replaceable light source
11