Home Zone Security MK-SC0108 Manual Del Usuario página 5

OPERATION (Continued)
3. Rotating the sensor controls downward
Rotate the motion sensor so the controls face toward the ground.
DISTANCE Setting
Adjust the DISTANCE setting to adjust range of Passive
Infrared Motion Sensor.
- Slide the "DIST" switch toward the "
short detection range.
- Slide the "DIST" switch toward the "
for middle detection range.
- Slide the "DIST" switch toward the "
long detection range.
The higher the "DIST" setting (Distance), the greater the possibility of false triggering.
To reduce false triggering, suggest to slide the "DIST" switch toward the "
setting if you don't need long detection distance while using this light.
LUX Setting
This setting is used to control the ambient light level for
the motion security light to turn on after motion detection.
- Slide the "LUX" switch toward the "
turn on in the daylight or in sunset or in the darkness.
- Slide the "LUX" switch toward the "
turn on in the sunset or in the darkness.
- Slide the "LUX" switch toward the " " position, the light will
turn on in the darkness.
08
DIST
DIST
" (low) position for
" (middle) position
" (high) position for
" position, the light will
" position, the light will
OPERATION (Continued)
TIME Setting
This setting is used to control the time span of how long
the light remains on when motion is detected.
- Set the " " switch to the 1, 3, 7 minute position.
The security light will stay on as long as motion is
detected and will go off after the time span you set
after no motion is detected.
4. Manual Override Function
This feature only works at night and only for one night at a time.
When power is on, the PIR sensor enters a "warm-up" period for about 15 seconds, then
automatically switches into AUTO MODE.
During AUTO MODE, by switching the main switch OFF-ON-OFF-ON within 3 seconds, the
PIR sensor will automatically change into MANUAL MODE from AUTO MODE. In MANUAL
MODE, the lights will remain ON, and will NOT be controlled by time duration or ambient
light (LUX) levels. The MANUAL MODE will change to AUTO MODE in 6 hours automatical-
ly or will change back to AUTO MODE if dawn is reached.
During MANUAL MODE, by switching the main switch OFF over 10 seconds then back ON
again, the PIR sensor will reset to the "warm-up" period.
DIST
" (low)
5. Blue LED sensor indicator
The Blue LED Light will flash to show that the PIR sensor is functioning properly.
SPECIFICATIONS
1. Detection Method: Passive Infrared Sensor (PIR). PIR measures infrared light radiating
from objects in its field of view. Apparent motion is detected when infrared levels change.
2. Sensor Range: Up to 21.3 m / 70 ft. x 240 degree spread (Varies with surrounding
temperature).
3. Time Adjustment: 1, 3, 7 minutes.
4. Power Source: 220~240VAC, 50/60Hz.
5. Load Rating: No extra lights should be added to this unit.
6. The LED chips are not replaceable.
09