Home Zone Security MK-SC0108 Manual Del Usuario página 4

INSTALLATION (Continued)
Step 3. Mounting the Light Fixture
Align the bottom edge of the Light Fixture (A) with the bottom edge of the Mounting Plate
(D). Tilt the light fixture (A) toward the Mounting Plate (D), making sure the Light Fixture (A)
is centered on the Mounting Plate (D).
Tighten the mounting blot pre-installed in Light Fixture (A) securely through the center of the
Mounting Plate (D). Do not overtighten.
Push the Decorative Cover (C) firmly into the mounting bolt hole on the Light Fixture (A).
C
H
Step 4. Caulking Around the Light Fixture
Caulk around the canopy and mounting surface with silicone sealant (not included).
06
A
OPERATION
1. Adjusting the Lamp heads and Sensor
Lamp heads can be adjusted easily. You may adjust the lamp head left and right or up and
down to get the desired lamp direction.
Sensor can be adjusted easily. You may adjust the sensor left and right or up and down to
get the desired lamp direction.
Note: LED LAMPS ARE NON-REPLACEABLE. Do not attempt to access / maintain the
LEDs; they are non-replaceable and any contact may damage the LEDs and will void the
warranty.
2. Adjusting the detector
After installing your motion activated light, you are ready to set /aim the motion detector.
Detection Range: around 21.3 m / 70 ft. x 240 degrees (Max)
You must aim the detector head to cover the desired area.
Note: Actual detection range may be affected by ambient temperature.
- Adjust the sensor head horizontal for long coverage.
2.5 m
/ 8.2 ft
1 m / 3.2 ft
35º 35º
70º
100º 100º
90º 90º
80º
21.3 m / 70 ft
90°
18 m / 59 ft
140°
12 m / 39.3 ft
180°
1 m / 3.2 ft
240°
21.3 m / 70 ft
70º
07