Craftsman 580.752210 Manual Del Operador página 10

HighAltitude
At altitudesover5,000 feet (1524 meters),a minimum 85 octane
/ 85 AKI (89 RON)gasolineis acceptable. T o remainemissions
compliant,high altitudeadjustmentis required.Operationwithout
this adjustmentwill causedecreased performance,increasedfuel
consumption,and increasedemissions.Seea qualifiedSears
dealerfor high altitudeadjustment information.Operationof the
engineat altitudesbelow2,500 feet (762 meters)with the high
altitudekit is not recommended.
Connect Hose and Water Supply to Pump
NOTE:Removeand discard the shipping caps from the pump's
high pressure outlet and water inlet beforeattaching hoses.
NOTICE
DO NOT run the pump without the water supply connected
and turned on.
Damage to equipment r esultingfrom failureto follow this
instructionwill void warranty.
Uncoil high pressure hose and attach one end of hose to
base of spray gun. Tighten by hand.
WARHIHG
The high pressure stream of water that this
_ quipment produces can cut through skin and its
underlying tissues, leading to serious injury and
_ossibleamputation.
* NEVER connecthigh pressurehoseto spraytip extension.
* Keephigh pressurehoseconnected to pumpand spraygun
whilesystemis pressurized.
* Alwaysbecertainspraygun,spraytips and accessories are
correctlyattached.
2. Attach other end of high pressure hose to high pressure
outlet on pump. Tighten by hand.
,
Before connecting garden hose to water inlet, inspect
inlet screen (A). Cleanscreen if it contains debris or have
it replacedif damaged. DO NOTrun pressurewasher if
inlet screenis damagedor missing.
4. Run water through garden hose for 30 seconds to flush
it of debris. Turn off water.
IMPORTANT:DO NOTsiphon standing water for the water
supply. Use ONLYcold water (less than I O0°F).
HOTICE
Using a OneWay Valve (vacuum breaker or check valve) at
pump inlet can cause pump or inlet connector damage.
ThereMUSTbe at leastten feet of unrestricted gardenhose
between thepressurewasherinletand anydevice,suchas a
vacuumbreakeror checkvalve.
Damage to equipment r esultingfrom failureto followthis
instructionwill void warranty.
5. Connectgarden hose (not to exceed 50 feet in length) to
water inlet. Tighten by hand.
WARHIHG
,_ Risk of eye injury.
_Spray can splash back or propel objects.
Alwayswearsafetygoggles when usingthis equipment o r in
vicinityof whereequipment i s in use.
Beforestartingthe pressurewasher,be sureyouare wearing
adequate safetygoggles.
NEVER substitutesafetyglassesfor safetygoggles.
6. Turn ON the water, press red button (B) on the gun and
squeezethe trigger to purge the pump system of air and
impurities.
Checklist Before Starting Engine
Reviewthe unit to ensure you have performed all of the
following:
1. Be sure to read Safety Rules and Operationsections
before using the pressure washer.
2. Make sure handle is in place and secure.
3. Checkthat oil has been added to proper level in engine
crankcase.
4. Add proper fuel to fuel tank.
5. Checkfor proper hose connections (high pressure and
water supply) and that there are no kinks, cuts, or
damageto the high pressure hose.
6. Provide proper water supply (not to exceed IO0°F).
10