Craftsman 580.752210 Manual Del Operador página 8

,
,
,
Attach rope guide (A) through handle with plastic knob
(B). Tighten by hand. Route engine recoil rope through
guide.
Align hose wrap (C) to the back side of accessory tray.
Locate notch with "unlock" icon (D) on hose wrap.
Position notch at top with hose wrap in vertical position.
Clips in the back of accessory tray should slide into the
grooves on the inside surface of hose wrap. Slide hose
wrap on back of accessory tray and rotate 1/8 turn until
"locked"icon (E) is in vertical position. Hose wrap is
easily removed from the accessorytray for wrapping and
unwrapping of the high pressure hose. A clip to secure
the hose on the reel makes it easy to wrap the hose
while it is detached from the accessory tray.
-% \
Attach bottle brackets (F) to handle supports with
carriage bolt (G) and black plastic knob (H). Tighten by
hand.
2-1N-1 Soap System
The pressure washer is equipped with two detergent
siphoning hoses.
TM
Project Pro PerfectMix Siphon
Blue tube with blue bottle cap:
TM
When using the blue PerfectMix siphon, use
, the PerfectMix
TM
Extreme Concentrate straight
i from the bottle
Standard Siphon Tube
Cleartube with filter:
When using the clear siphon tube, dilute
1 part PerfectMix
TM
ExtremeConcentrate
to 16 parts water (4 oz of concentrate
makes 1/2 gallon of mix.)
Attach Project Pro@ PerfectMix
TM
Siphon to
Pump
Attach the hose end of the blue PerfectMWMSiphon (J) to
the barbed hose fitting (K) on the pump.
Attach PerfectMix
TM
Detergent Siphon to
Concentrate Bottle
Place PerfectMix
TM
bottle (not included) in the wire-form
bracket on the handle. Removecap from bottle and insert the
PerfectMix
TM
Siphon (L). Screw the siphon unit to the top of
the bottle (M). Usethe clip on the cap (L) to snap siphon to
wire form bracket when siphon is not in a concentrate bottle.
®
Add Enoine Oil
1. Placepressure washer on a flat, ]eve]surface.
2. Cleanarea around oil fill and remove yellow oil fill
cap/dipstick.
3. Using oil funnel (optional), slowly pour contents of
provided oil bottle into oil fill opening.
NOTICE
Improper treatment of pressure washer can damage it and
shorten its life.
DONOTattemptto crankor startthe enginebeforeit hasbeen
properlyservicedwith the recommended o il. This may resultin
an enginefailure.
4. Replace oil fill cap/dipstick and fully tighten.