Craftsman 580.752210 Manual Del Operador página 9

Add FueJ
Fuel must meet these requirements:
* Clean, fresh, unleadedgasoline.
. A minimum of 87 octane/87 AKI (91 RON). High altitude
use, see High Altitude.
* Gasolinewith up to 10% ethanol (gasohol) or up to 15%
MTBE (methyl tertiary butyl ether) is acceptable.
HOTJCE
Avoid pressure washer damage.
Failureto follow Operator's Manual for fuel
recommendations voids warranty.
DONOTuseunapproved gasolinesuchas E85.
DONOTmix oil in gasoline.
DONOTmodifyengineto run on alternate fuels.
To protect the fuel system from gum formation, mix in a fuel
stabilizerwhen adding fuel. See Storage.All fuel is not the
same. If you experiencestarting or performanceproblems after
using fuel, switch to a different fuel provider or changebrands.
This engineis certified to operateon gasoline. Theemission
control system for this engine is EM (Engine Modifications).
WARHJHG
f_ Fueland its vapors are extremely flammable and
explosive.
Fire or explosion can cause severe burns or
death.
WHEHADDINGFUEL
* Turnpressure washerOFF and let it coolat least2 minutes
beforeremovingfuelcap. Loosencapslowlyto relievepressure
in tank.
Fillfueltank outdoors.
DONOToverfilltank.Allowspacefor fuelexpansion.
. If fuel spills,wait until it evaporates beforestartingengine.
* Keepfuelawayfrom sparks,openflames,pilot lights,heat,and
otherignitionsources.
DONOTlight a cigaretteor smoke.
1. Cleanarea around fuel fill cap, remove cap.
2. Slowly add regular unleaded fuel (A) to fuel tank (U). Be
careful not to overfill. Allow about 1.5" (4 cm) (C) of tank
space for fuel expansion.
3. Install fuel cap and wait for any spilled fuel to evaporate.
CAUTION! Alcohol-blended fuels (called gasohol, ethanol or
methanol) can attract moisture, which leads to separation and
formation of acids during storage. Acidic gas can damagethe
fuel system of an engine while in storage.
To avoid engine problems, the fuel system should be treated
with a fuel preserver or emptied before storage of 30 days or
longer. If adding a fuel preserver, fill the fuel tank with fresh
fuel. if only partially filled, air in the tank will promote fuel
deterioration during storage, if fuel preserver is not used,
drain the fuel tank, start the engine and let it run until the fuel
lines and carburetor are empty. Use fresh fuel next season.
See Storage for additional information.
NEVERuse engine or carburetor cleaner products in the fuel
tank as permanent damage may occur.
FreshStart FuelCap
Adding fuel preserver helps keep fuel fresh and carburetors
clean for easier starting, all season long. This new fuel cap
automatically drips concentrated fuel preserver into your fuel
tank.
, DANGER
Contents are harmful or fatal if swallowed. Avoid
_ ontact to eyes, skin or clothing. DO NOTtake
internally. Avoid breathing the mist or vapor.
Overexposureto eyes or skin can cause irritation.
Keepstabilizer out of the reachof children.
Fuelstabilizer is a hazardous chemical.**
o If SWALLOWED, callphysicianimmediately.
o In the caseof an emergency, contacta physicianimmediately
andcall 1-800-424-9380 for materialsafetyinformation.
**Fuel stabilizer contains: 2,6-di-tret-butylphenol (128-39-2) and alipbatie petroleum
distillate (64742-47-8).
Placecartridge into fuel cap.
,
3.
/
Push to "snap" cartridge into place.
Removetab to expose membrane.
IMPORTANT:DO NOT remove the silver foil seal on the
opposite side.
4. Reinstall fuel cap on fuel tank.
5. Periodically check the cartridge to ensure there is still
fuel stabilizer inside. If it is empty, remove cartridge and
replace.