Setting The Security Code - GE 29893 Guia Del Usuario

S
ETTING THE
This feature allows you to change the factory default
remote access code used for remote access to you
answerer. The default code is 123.
1. If you just adjusted the Rings to Answer menu, skip to
step 2. If you haven't adjusted any other setting, press
and release the MENU button until REMOTE ACCESS
is displayed.
2. Use NEXT or PREVIOUS to select the first digit.
3. Once the first digit is set, press ENTER.
4. Repeat steps 2-3 until all the digits of the security
code are set.
5. When finished, press ENTER to confirm. The unit beeps.
NOTE: To skip to the next setting, press MENU. To
exit setup, press PLAY/STOP.
TIP: You can use the keypad to enter all the digits in one
step. To enter 456, press 4,5, and 6. Then press ENTER.
16
All manuals and user guides at all-guides.com
S C
ECURITY ODE
MENU button
PREVIOUS button
ENTER button
PLAY/STOP
button
N
ERASE
MEM DIAL STORE
1 2
A
ABC DEF
QUICK DIAL
4 5
B
GHI JKL MNO
7 8
PQ
C TUV
RS
MEM DIAL
0
*
TONE OPER
mic
NEXT button
O
VOL +
ON/OFF
VOL -
FLASH
3
REDIAL/PAUSE
6
HOLD
9
WX
YZ
#
SPEAKER