Philips AZ 1018 Manual Del Usuario página 13

Recording
Synchro Start CD recording
1 Select CD source.
2 Insert a CD and if desired, programme
track numbers.
3 Press STOP•OPEN 9/ to open the
cassette door. Insert a blank tape.
4 Close the cassette door.
5 Press RECORD 0 to start recording.
• Playing of the CD programme starts
automatically from the beginning of the
programme. It is not necessary to start the
CD player separately.
6 For brief interruptions press PAUSE ;.To
resume recording, press PAUSE ; again.
7 To stop recording, press STOP•OPEN 9/.
Selecting and recording a particular
passage
• During CD playback, press and hold down
the SEARCH buttons ∞ or § on the set
to find your passage.
• Press PLAY•PAUSE 2; to put the CD
player on pause at the selected passage.
Recording will begin from this exact
point in the track when you press
RECORD 0.
All manuals and user guides at all-guides.com
Maintenance
Recording from the Radio
1 Select RADIO source and your waveband.
2 Tune to the desired radio station (see
Radio reception).
3 Press STOP•OPEN 9/ to open the
cassette door. Insert a blank tape.
4 Close the cassette door.
5 Press RECORD 0 to start recording.
6 For brief interruptions, press PAUSE ;.To
resume recording, press PAUSE ; again.
7 To stop recording,
press STOP•OPEN 9/.
Precautions &
General Maintenance
• Place the set on a hard and flat surface so
that the system does not tilt.
• Do not expose the set, batteries, CDs or
cassettes to humidity, rain, sand or excessive
heat caused by heating equipment or direct
sunlight.
• Do not cover the set. Adequate ventilation
with a minimum gap of 6 inches between
the ventilation holes and surrounding
surfaces is necessary to prevent heat build-
up.
• The mechanical parts of the set contain
self-lubricating bearings and must not be
oiled or lubricated.
• To clean the set, use a soft, slightly
dampened chamois leather. Do not use any
cleaning agents containing alcohol,
ammonia, benzene or abrasives as these
may harm the housing.
13