Using Ac Power; General Operation - Philips AZ 1018 Manual Del Usuario

Batteries contain chemical substances,
so they should be disposed of properly.
Incorrect use of batteries can cause
electrolyte leakage and will corrode the
compartment or cause the batteries to
burst.Therefore:
• Do not mix battery types: e.g. alkaline with
carbon zinc. Only use batteries of the same
type for the set.
• When inserting new batteries, do not try to
mix old batteries with the new ones.
• Remove the batteries if the set is not to be
used for a long time.

Using AC Power

1 Check if the mains voltage, as shown on
the type plate located on the bottom
of the set, corresponds to your local
mains supply. If it does not, consult your
dealer or service centre.
2 Connect the mains lead to the AC MAINS
inlet and the wall socket.The power supply
is now connected and ready for use.
3 To switch off completely, unplug the mains
lead from the wall socket.
• Unplug the mains lead from the wall socket
to protect your set during heavy
thunderstorms.
The type plate is located on the
bottom of the set.
All manuals and user guides at all-guides.com
Power Supply
Switching power on/off:
Save energy
Whether you are using mains or battery
supply, to avoid unnecessary energy
consumption always adjust the POWER
slider to TAPE/
OFF
cassette keys are released.

General operation

1 To select your sound source adjust the
POWER slider to CD, RADIO or
TAPE/ .
OFF
2 Adjust the sound with the VOLUME and
DBB (Dynamic Bass Boost) controls.
3 To switch off the set, adjust the POWER
slider to TAPE/
OFF
the cassette keys are released.
Note:When the set is switched off the tuner
presets will be retained in the set's memory.
and check if the
position and check
7