Radio Reception - Philips AZ 1018 Manual Del Usuario

Radio

Radio reception

1 Adjust the POWER slider to RADIO.
Display: shows tu briefly.The radio
frequency is then shown.
2 Press FM•MW once or more to select the
desired waveband.
Display: shows your waveband
3 Press and hold down SEARCH ∞ or §
briefly to tune to a radio station. Release
when the frequency in the display starts to
change.
The radio automatically tunes to a radio
station of sufficient reception. Display
shows Srch during automatic tuning.
• To tune to a weak station, press SEARCH
∞ or § briefly and repeatedly until you
have found optimal reception.
To improve reception
– For FM, pull out the telescopic aerial. Incline
and turn the aerial. Reduce its length if the
signal is too strong (very close to a
transmitter).
– For MW (AM) the set is provided with a
built-in aerial so the telescopic aerial is not
needed. Direct the aerial by turning the whole
set.
4 To switch off the radio, adjust the POWER
slider to TAPE/
OFF
the cassette keys are released.
8
All manuals and user guides at all-guides.com
position and check
Programming radio stations
You can store up to a total of 30 radio
stations in the memory.
1 Tune to your desired station (see Radio
Reception).
2 Press CD MODE/ PROGRAM to
activate programming.
Display:
PROGRAM
3 Press PRESET 3 or 4 once or more to
allocate a number from 1 to 30 to this
station.
4 Press CD MODE/ PROGRAM again to
confirm the setting.
Display:
PROGRAM
number and the frequency of the preset
station are shown.
5 Repeat the above four steps to store other
stations.
• You can erase a preset station by storing
another frequency in its place.
Tuning to preset stations
Press PRESET 3 or 4 until the desired
preset station is shown.
flashes.
disappears, the preset