Tabla de contenido
Publicidad
(pic. 20). Lead the Router with a light side pressure along the
edge of the piece to route.
DIRECTION OF CUT (PIC.16)
In order to avoid "bit chatter" and to obtain the best results, cuts
need to be made in an anti-clockwise direction for external cuts
and a clockwise direction for internal cuts (Pic. 16).
REPLACING THE CARBON BRUSHES
(PICS.17 & 18)
If the performance of your Router is poor or there is excessive
sparking visible through vents on top of the machine the carbon
brushes need replacing.
Remove the two cross head screws that secure the brush cover
(Pic. 17). Carefully remove the cover.
Locate the brushes (one each side) and lift upwards and
outwards. Be careful not to disturb any wiring. Hold the black
outer casing (18.1) and remove the spring loaded carbon brush
(Pic. 18).
Always replace in pairs obtainable from your stockist. Re-fit the
carbon brushes and place back into position. Repeat operation
for other side.
TECHNICAL SPECIFICATION
Voltage
Motor
Collett
Velocità variabile
Plunge depth
Sound Pressure Level
Sound Power Leve
Vibration Level
Weight
Ensure that the machines ventilation slots are kept clear
of sawdust/chippings etc. Keep plunge guides clean and
lubricated with a light multi purpose oil. There are no other user
serviceable parts in this unit.
NR1200
230V ~ 50 Hz
1200W
8 mm e 6 mm
11500 - 30000 min
-1
44 mm
L PA 82,23 dB(A)
L WA 95,23 dB(A)
3,84 m/s
2
5.5 kg
19
GB
Publicidad
Tabla de contenido
