Complete The Installation - Kohler 1052071 Manual De Instrucciones

Motor Wiring Loom
Connect the Wiring Looms
Connect the motor (2 connections), solenoid, and thermistor
wiring looms to the circuit board.
Verify all connectors and grommets are secured.

Complete the Installation

IMPORTANT! Position the wiring looms so that they are not
pinched when the cover is secured.
Reinstall the cover using the new screws provided.
Connect the power supply and turn on the water supply.
Enter the calibration code into the user interface. Path: Settings >
Valve > Service > Activation Code (1012)
Kohler Co.
Solenoid Wiring Loom
Motor Wiring Loom
Second Connection
(not all models)
Thermistor Wiring Loom
Circuit Board
7 1062947-9-D