Configuring 15000 / 23000 Appliances; Starting The Appliance - Check Point 15000 Serie Guía De Introducción

CHAPTE R 3
Configuring 15000 / 23000
Appliances
In This Section:

Starting the Appliance

Initial Configuration
Creating the Network Object
Advanced Configuration
Starting the Appliance
Connect the appliance to a power source and turn on the appliance. When the
appliance is ready, you can do the First Time Configuration Wizard to configure it.
To start the appliance:
1. Connect the power cables to the power supply units in the rear panel.
The appliance turns on.
2. From the rear of the appliance, turn on the Power button.
.........................................................................................
.............................................................................................
......................................................................................
Note - When a power supply unit cord is not connected to the outlet,
an alarm sounds continuously. If you hear the alarm, reconnect the
cord to the outlet.
To turn off the alarm, press the red Alarm off button on the rear panel
of the appliance.
The alarm is inactive for the first two minutes after startup.
Check Point 15000 and 23000 Appliances Getting Started Guide
..............................................................................
29
32
32
32
| 29