Squeegee Incidence Set Up - Ghibli FRECCIA 15 Manual De Uso Y Mantenimiento

EN
N.B.:
It is possible to have two types of rubber
blade.
Para rubber blades for all types of floor and
polyurethane rubber blades for mechanical
workshop floors which are dirty with oil.
11.1.g - Squeegee incidence set up
(Fig. 20)
- Lower the squeegee using the specific
lever.
- Start the suction unit and advance for
some metres before stopping the suction
unit and the machine.
- Check the angle of incidence of the rub-
bers (66) on the floor.
Fig. A = too squatted
Fig. B = too high
Fig. C = correct position.
- Take off the squeegee from the machine.
- To set up, loosen the screw (70) of the
wheel (71) and move the wheel vertically
in the slot; by lifting the wheel, the angle
of incidence increases, viceversa it de-
creases.
11.1.h - Replacing the fuses (for BC
version only) (Fig. 21)
WARNING:
Replace the blown fuse with one with the
same amperage.
- Pull the plug (21) (BC Long Run version
only).
- Unscrew the two bolts (72) that fasten the
external box (73) and remove it.
- Unscrew the two bolts (74) of the printed
circuit board (75) and remove it.
Fuse (76) Green 30A
Machine general protection.
- Put the cover (75) and the box (73) back
into place in reverse sequence.
All manuals and user guides at all-guides.com
EN-12