Listening To Each Programmeme Source In Its Registered Equalizer Curve; Registering An Equalizer Curve Onto Each Disc - Sony XDP-210EQ Manual De Instrucciones

3
Adjust the cut-off frequency
1 Press (1) (N) or (4) (n) to select the
line out.
SUB (Subwoofer) ˜ F (Front)
˜ R (Rear)
CNW
SUR EQ
2 Rotate/press (+) to select the desired
cut-off frequency.
Subwoofer :
50 Hz n 62 Hz n 78 Hz n 99 Hz n 125 Hz
n 157 Hz
Front, Rear:
Flat n 78 Hz n 99 Hz n 125 Hz n 157 Hz
n 198 Hz
CNW
SUR EQ
If you rotate/press (–), the cut-off
frequency appear in the reverse order.
EN
3 Repeat steps 1 and 2 to select the
cut-off frequency.
4
Press (SOUND) for two seconds.
When the cut-off frequency setting is
complete, the display goes back to the
normal playback mode.
Tip
To adjust the subwoofer level, select "SUB" by pressing
(1) (N) or (3) (n) after step 3 above. Then rotate/press
(+) or (–) to adjust the level. When you finish adjusting
the subwoofer level, press (SOUND) for two seconds.
Listening to each program
source in its registered
equalizer curve
— Source Sound Memory
You can listen to the same source (CD, MD,
TAPE, FM and AM) always in the same
equalizer curve and sound characteristics
(bass, treble and subwoofer level) even after
changing the program source or turning the
unit on and off again.
8
Cut off
F Flat
Cut off
F 125Hz
Registering an equalizer
curve onto each disc
— Disc Sound Memory (DSM)
(CD/MD changer or CD/MD player with
program memory function)
Once you have registered the desired equalizer
curve and the sound characteristics (bass,
treble and subwoofer level) onto the discs, you
can enjoy the same equalizer curve every time
you play them. You can register up to 200
discs.
1
Play the desired disc.
2
Select the equalizer curve, and adjust the
sound characteristics.
3
Press (SHIFT), then press (3) (PLAY
MODE) repeatedly until "DSM SET"
appears.
CD1 SCHUBERT
DSM set
SUR EQ
4
Press (5) (ENTER) momentarily.
DSM
+Enter+
SUR EQ
When the DSM setting is complete, the
display will go back to the normal playback
mode.
Changing the stored equalizer
curve
Play the disc whose equalizer curve you want
to change, and follow the "Setting and storing
the equalizer curve".
Erasing the stored equalizer curve
1
Press (SHIFT), then press (3) (PLAY
MODE) repeatedly until "DSM SET"
appears.
2
Press (5) (ENTER) for two seconds.
DSM
+Delete+
SUR EQ