Druck PM700E Manual De Inicio Rápido página 8

5. NPT female to G1/8 male adapter IO-ADAPT-1/4NPT
or IO-ADAPT-1/8NPT.
Electrical Connection
The equipment has a single electrical port, item 1 in
Figure A4. This is for connecting to DPI 705E or
DPI 705E-IS via the supplied 2.9 metre (9.5 feet) cable.
For the entity parameters, refer to Table A3.
Specific Conditions of Use
1. The remote sensor PM 700E-IS shall only be
connected to suitably certified Druck digital handheld
equipment via cable provided by the equipment
manufacturer.
2. CAUTION: The metal body of the remote sensor
PM 700E-IS is connected directly to the circuit earth of
the handheld pressure indicator. The equipment is
battery powered only and not intended to be connected
to any external electrical connection.
Declaration Requirements – EU Directive 2014/34/EU
This equipment is designed and manufactured to meet the
essential health and safety requirements not covered by
EU Type Examination Certificate SIRA 19ATEX2037X
when installed as detailed above.
Pressure Safety
This equipment meets the requirements of the European
Pressure Equipment Directive 2014/68/EU and
UL 61010-1 for pressure safety. The 1400 bar (20,000 psi)
sensor shall only use group 2 liquids as the pressure media
at volumes of less than 10 litres (2.6 gallons).
Return Goods/Material Procedure
If the unit requires calibration or is unserviceable, return it
to the nearest Druck Service Centre listed at:
Druck.com/essential
Do not dispose of this product as household waste. Use
an approved organization that collects and/or recycles
waste electrical and electronic equipment. For more
information, contact one of these:
- Our customer service department:
Druck.com/essential
- Your local government office.
Contact the Service Department to obtain a Return
Goods/Material Authorization (RGA or RMA). Provide the
following information for a RGA or RMA:
• Product (i.e. PM 700E / PM 700E-IS)
• Serial number.
• Details of defect/work to be undertaken.
• Calibration traceability requirements.
• Operating conditions.
Operation
Connect the PM 700E / PM 700E-IS pressure sensor to the
accessory/remote port of the DPI 705E or DPI 705E-IS test
instrument using the supplied 2.9 metre (9.5 ft) cable. On
connection the test instrument will briefly display the
sensor's full scale pressure range.
The DPI 705E / DPI 705E-IS will automatically switch from
displaying readings from the internal pressure sensor to the
remote pressure sensor when a remote sensor is plugged
in.
Copyright 2019 Baker Hughes Company.
2 | PM 700E / 700E-IS Safety Manual–English