Making Minor Adjustments Between Doors; Installing The Water Dispenser Line; Connecting To The Water Supply Line - Samsung RF323TE Manual Del Usuario

MAKING MINOR
ADJUSTMENTS BETWEEN
DOORS
Remember, a leveled refrigerator is necessary
for getting the doors perfectly even. If you need
help, review the previous section on leveling the
refrigerator.
The left door is fi xed. To make minor
adjustments between doors, adjust only
the right door.
1. Pull out the freezer drawer (
lower hinge ( 2 ).
2. Insert the supplied allen wrench (3/16") (
into the shaft ( 4 ) of the lower hinge.
3. Adjust the height by turning the hex wrench (
clockwise ( ) or counter clockwise (
DOWN DOWN
When you turn the hex wrench counter-
clockwise (
1
4. After adjusting the doors, insert the supplied
fastener ( 6 ) using a pliers ( 5 ) in the gap
between the hinge-grommet ( 7 ) and the lower
hinge ( 8 ). The number of fasteners you'll need
to insert depends on the gap.
10_ setting up
DA68-02603A.indb 10 DA68-02603A.indb 10
All manuals and user guides at all-guides.com
Adjustment Adjustment
part part
Fixed part Fixed part
1 ) to reveal the
3 )
3 )
UP UP
).
), the door will move up.
2
3
3
4
2 fastener are enclosed with the refrigerator.
The thickness of each fastener is 0.04".
INSTALLING THE WATER
DISPENSER LINE
A water dispenser with a fi lter is one of the helpful
features on your new refrigerator. To help promote
better health, the water fi lter removes unwanted
particles from your water. However, it does not
sterilize or destroy microorganisms. You may need
to purchase a water purifying system to do that.
The water line also connects to the ice maker.
For the ice maker to operate properly, water
pressure of 20-125 psi (138 ~ 862Kpa) is required.
If the refrigerator is installed in an area with low
water pressure (below 20psi), you can install
a booster pump to compensate for the low
pressure.
After you have connected the water line, make
sure the water storage tank inside the refrigerator
is properly fi lled. To do this, press the water
dispenser lever until the water runs from the water
outlet.
Water line installation kits are available at
extra cost from your dealer.
We recommend using a water line
installation kit that contains copper tubing
and ¼" compression nut.

Connecting to the water supply line

1. First, shut off the main water
supply.
2. Locate the nearest cold water drinking line and
install the pipe clamp and shut off valve.
Cold water line Cold water line
Pipe clamp Pipe clamp
Shut off valve Shut off valve
3. Connect the water line installation kit to the
shut off valve.
2012.5.30 1:25:41 PM 2012.5.30 1:25:41 PM