Hansgrohe Talis S 32420000 Instrucciones De Montage página 21

Important! The fitting must be installed, flushed and
tested after the valid norms!
Assembly
1. Flush through the supply pipes.
2. Mount the ball S - unions.
3. Fasten the mixer with the washers.
The hot and cold supplies must be of equal
pressures.
Operation
The mixer is activated by lifting the lever handle.
Turning to the left = warmer water,
turning to the right = cooler water.
32420000/32473000: The flow is changed from bath
to shower function by pulling the knob at the upper
side of the spout. After shutting off the water flow,
the mixer returns automatically to the bath function.
Technical Data
Operating pressure:
Recommended operating pressure:
Test pressure:
( 1 MPa = 10bar = 147 PSI )
Hot water temperature:
Recommended hot water temp.:
Centre distance:
Connections G ½":
Rate of flow:
4
English
max. 1 MPa
0,1 – 0,5 MPa
1,6 MPa
max. 80° C
65° C
cold right - hot left
ca. 18 l/min 0,3 MPa
anti-pollution function
Hansgrohe single lever mixers can be used together
with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 0,15 MPa.
To adjust the hot water limiter on single lever
mixers, please see page6.
No adjustment is necessary when using a
continuous flow water heater.
Important!
The non return valves must be checked once a
year.
Spare parts (see page 3)
1 handle
1.1 screw cover
2 flange
3 nut
4 cartridge cpl.
5 locking screw for handle
6 flange Ø 68 mm
7 S - unions (2)
8 noise reduction (2)
9 aerator cpl. (10)
10 selector assy
11 diverter knob
12 non return valve DW 15 (10)
13 hose connection
32092000
96338000
96656000
96690000
92730000
96059000
96467000
94140000
96429000
13956000
94077000
96466000
94074000
96044000