Sinbo SSI 2867 Manual Del Usuario página 12

6. HOW TO FILL WITH WATER
* Remove the plug from the stock
* Fill the water through the filling opening into the water tank.
* If the water is very hard, it is advised to use distilled water or
demineralized water only. Do not use chemically descaled water.
* Pour out the remaining water after use.
7. SURGE STEAM IRONING
The surge-of-steam feature provides powerful steam for removing
stubborn wrinkles.
* Fill the iron with water as described in "How to fill with water".
* Plug iron into electrical outlet.
* As indicated on the temperature control knob, steam ironing is only possible at higher
temperature setting indicated with 'MAX' mark, otherwise the water will leak from the
soleplate.
* Turn the temperature control knob to the position according to the fabric being ironed
as described in point 6 of 'Setting the temperature'
* The indicator light will turn 'OFF' when the indicated setting reaches the correct
temperature.
* Press the Steam jet button to release the surge-of-steam. Pressing the button several
times may be necessary to prime the surge system..
* Wait a few seconds for the steam to penetrate the fabric before pressing the button
again for more steam.
* NOTE: For optimum steam quality, do not apply more than four successive 'SHOT' after
the indicator light goes off.
8. CLEANING
Please note: before cleaning the iron in any way, make sure that the appliance plug is
not connected to the socket.
Any deposits, starch residue or size left on the plate can be removed using a damp cloth
or an unabrasive liquid detergent.
Avoid scratching the plate with steel wool or metallic objects.
The plastic parts can be cleaned with a damp cloth then wiped over with a dry cloth.
- 11 -